Whirlpool 3WSC19D4AY00 Istruzioni per l'utente - Pagina 9

Sfoglia online o scarica il pdf Istruzioni per l'utente per Frigorifero Whirlpool 3WSC19D4AY00. Whirlpool 3WSC19D4AY00 24.

Stampa la pagina

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

NOTES:

The cabinet depth refrigerator can be installed into a recessed

opening, at the end of cabinets or as a freestanding

refrigerator.

If you are installing the refrigerator to fit flush with the front of

the base cabinets, all shoe molding and baseboards must be

removed from the rear of the refrigerator opening. Allow for

1" (2.54 cm) of space behind the refrigerator.

Location should permit doors to open fully. See the "Door

Swing Dimensions" section.

This refrigerator is intended for use in a location where the

temperature ranges from a minimum of 55°F (13°C) to a

maximum of 110°F (43°C). The preferred room temperature

range for optimum performance, which reduces electricity

usage and provides superior cooling, is between 60°F (15°C)

and 90°F (32°C). It is recommended that you do not install the

refrigerator near a heat source, such as an oven or radiator.

Floor must support refrigerator weight (more than 600 lbs

[272 kg], door panels and contents).

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded (earthed) outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical connection:

Recommended Grounding Method

A 115 Volt 60 Hz. (Plug 1), 220/240 Volt 50 Hz. (Plugs 2 or 3), or

220 Volt 60 Hz. (Plug 3) AC only 10-amp fused and grounded

(earthed) electrical supply is required.

Plug 1

Plug 2

It is recommended that a separate circuit serving only your

refrigerator be provided. Use an outlet that cannot be turned off

by a switch or pull chain. Do not use an extension cord.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the control, (Thermostat, Refrigerator

or Freezer Control depending on the model) to OFF and then

disconnect the refrigerator from the electrical source. When you

are finished, reconnect the refrigerator to the electrical source and

reset the control (Thermostat, Refrigerator or Freezer Control

depending on the model) to the desired setting.

For Australia and New Zealand:

Your new appliance has been especially manufactured to meet all

Australian Standards and Conditions.

Some notations in the installation instructions may refer to

electrical requirements in other countries, so we draw your

particular attention to these specific notes.

Your appliance needs to be plugged into a 230/240 Volt 50 Hz.

10-amp (Plug 4) AC only earthed outlet.

Plug 3

Plug 4