Ariston ASL 75 CXS NA Libretto di cura, uso e installazione - Pagina 9

Sfoglia online o scarica il pdf Libretto di cura, uso e installazione per Asciugatrice Ariston ASL 75 CXS NA. Ariston ASL 75 CXS NA 40. Condensation dryer
Anche per Ariston ASL 75 CXS NA: Scheda tecnica (1 pagine), Opuscolo e specifiche (8 pagine), Manuale d'uso e d'installazione (40 pagine), Manuale di riparazione (18 pagine)

Ariston ASL 75 CXS NA Libretto di cura, uso e installazione

Maintenance and Care

When to switch off the electricity

! Unplug your dryer when not using it, when cleaning
it and during maintenance activities.

Clean the filter after each cycle

The filter is an important part of your dryer:
it accumulates lint and fluff that is formed while drying.
When finished drying, clean the filter by rinsing it
under running water or with your vacuum cleaner.
Should the filter become clogged up, the airflow inside
the dryer will be seriously compromised: drying times
lengthen and you will consume more energy. It may
also damage your dryer.
The filter is found in front of the dryer trim (see diagram).
Removing the filter:
1. Pull the plastic grip of the filter upwards (see diagram).
2. Clean the filter and replace it correctly.
Ensure the filter is fully located flush into the tumble
dryer trim.
! Do not use the dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small items
(handkerchiefs) that could have been left behind.
Cleaning the drum
! Do not use abrasives, steel wool or stainless steel
cleaning agents to clean the drum.
A coloured film may start to appear on the stainless
steel drum, this may be caused by a combination of
water and, or cleaning agents such as fabric conditioner
from the wash. This coloured film will not affect the
dryer performance.
Condenser cover
www.aristonappliances.us
Filter
Catches
Handle
Cleaning the condenser unit
Periodically (every month) remove the condenser unit
and clean any build up of fluff from between the plates
by rinsing it under the tap with cold water.
This should be done with cold water from the rear of
the condenser.
To remove the condenser:
1. Unplug the dryer and open the door.
2. Pull open the condenser cover (see diagram).
Release the three catches by turning 90˚ counter-
clockwise then pull on the grip and remove from
the dryer.
3. Clean the surface of the seals and replace, making
sure that the catches have been secured.

Cleaning the dryer

External parts in metal or plastic and rubber parts
can be cleaned with a damp cloth.
Periodically (every 6 months) vacuum the front air
intake grille and vents at the rear of the dryer, to
remove any build up of fluff, lint or dust. Also to
remove accumulation of fluff from the front of the
condenser and filter areas, clean occasionally with
a vacuum cleaner.
! Do not use solvents or abrasives.
! Your dryer uses special bearing components which
do not need lubrication.
! Have your dryer checked regularly by authorized
technicians to ensure electrical and mechanical safety.
Tap
Condenser unit
Air Intake
Rear
Front
9
EN