Cal Spas Cal Salt Spa Sanitation System Manuale operativo - Pagina 13
Sfoglia online o scarica il pdf Manuale operativo per Accessories Cal Spas Cal Salt Spa Sanitation System. Cal Spas Cal Salt Spa Sanitation System 16.
Stampa la pagina7. Operation Mode and Trouble Shooting
7. Operation Mode and Troubleshooting
7. Operation Mode and Troubleshooting
Operation Mode and Trouble Shooting
Symptom on
Power Supply
Display
LED
no display
1
no
lights
2
no
"−−"
lights
3
"−−" and
no
Hours (05
lights
by default)
alternating
4
"LO"and
Yellow
Hours (05
light
by default)
alternating
5
Hours (05 by
Green
default)
light
6
"HI" and
Red
Hours (05
light
by default)
alternating
7
"HI"
Red light
blinking
8
"88" blinking
All lights
blinking
Symptom in Spa Water
9
chlorine level is low
10
chlorine level is too high
Possible Causes
Solution
1 - power outage
Make sure there is power to the unit.
2 - power supply failure
Need to replace the power supply.
unit in rest mode
No action is needed. If you want it to operate
immediately, unplug/plug the power or adjust the timer.
Both will start the operation right away.
1 - chlorinator cell is
Put it back in to the water.
outside water
2 - open circuit in
Check the wire connections and make sure no cut or
chlorinator cell
broken wire.
3 - salt level low
Add more salt to spa and allow time for it to dissolve.
1 - salt level low
Add more salt to spa and allow time for it to dissolve.
2 - water temperature
Don't use if the water temperature is under 15
low
default)
3 - chlorinator cell at its
Need a new cell replacement
life end
normal operation mode
No action is needed.
1 - salt level high
No action is needed. Stop adding salt to water if you are
doing so.
2 - water temperature
Using unit for water temperature above 45
high
not recommended.
1 - salt level too high or
You will have to dilute your spa water with fresh water
high TDS Levels
until the salt level is less than 3000 ppm. Dead Sea Salt
can cause HI on the Mini.Also,check your TDS Levels.
2 - water temperature
Stop using unit until water cools down.
too high
3 - short circuit in
Check to make sure there are no metal objects caught in
chlorinator cell
between electrode plates.
Power supply failure
Unplug and plug in the power cord to reset the power
supply.If the problem persists, call customer service.
Hours set too low
Adjust the hours setting to higher number (the maximum
is 24 hours/day).
Make sure cyanuric acid level in your spa is between
50 - 80 PPM.
Hours set too high
Adjust the hours setting to lower number (the minimum
is 0 hours/day).
11
C (65
F).
o
o
C (110
F) is
o
o
13