Whirlpool WED7500VW Manuale d'uso e manutenzione - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Asciugatrice Whirlpool WED7500VW. Whirlpool WED7500VW 20. Compact electric dryer with 11 cycles
Anche per Whirlpool WED7500VW: Manuale d'uso e manutenzione (20 pagine), Specifiche tecniche (8 pagine), Dimensioni e informazioni sull'installazione (1 pagine), Manuale di istruzioni (8 pagine), Istruzioni per l'installazione (2 pagine)

1. Loosen or remove center terminal block screw.

2. Place the hooked end of the neutral wire (white or center wire)

of power supply cable under the center screw of terminal

block (hook facing right). Squeeze hooked end together.

Tighten screw.

A. Neutral wire (white or center wire)

B. Center terminal block screw

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death

or fire.

Choose your exhaust installation type

Recommended exhaust installations

Typical installations vent the dryer from the rear of the dryer.

A. Exhaust hood

B. Flexible metal vent or rigid metal vent

C. Elbow

3. Place the hooked ends of the other power supply cable wires

4. Replace the terminal block cover on the back of the dryer.

5. Tighten strain relief nut.

Plan Vent System

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best for

your installation. A close-clearance installation is shown below.

Refer to the manufacturer's instructions.

Over-the-Top Installation Kit Part Number 4396028 for close

clearance alternate installation is available for purchase. For

ordering information see "Assistance or Service."

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible

portion of the mobile home structure and must not terminate

beneath the mobile home. Terminate the exhaust vent outside.

under the outer terminal block screws (hooks facing right).

Squeeze hooked ends together. Tighten screws.

Over-the-top installation (also available with one offset elbow)