Whirlpool 29" Manuale di istruzioni per l'installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Asciugatrice Whirlpool 29". Whirlpool 29" 22. Dryer
Anche per Whirlpool 29": Manuale di istruzioni per l'installazione (48 pagine)

Stampa la pagina

Venting Requirements

WARNING:

To reduce the risk of re, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT:

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace, or a concealed space

of a building. Only rigid or exible metal vent shall be used for

exhausting.

4" (102 mm) heavy metal exhaust vent

Only a 4" (102 mm) heavy metal exhaust vent and clamps

may be used.

Do not use plastic or metal foil vent.

Rigid metal vent:

Recommended for best drying performance and to avoid

crushing and kinking.

Flexible metal vent:

(Acceptable only if accessible to clean)

Must be fully extended and supported in nal dryer location.

Remove excess to avoid sagging and kinking that may result

in reduced air ow and poor performance.

Do not install in enclosed walls, ceilings, or oors.

The total length should not exceed 7

NOTE:

If using an existing vent system, clean lint from entire

length of the system and make sure exhaust hood is not

plugged with lint. Replace plastic or metal foil vents with rigid

metal or exible metal vents. Review "Vent System Chart" and,

if necessary, modify existing vent system to achieve best drying

performance.

VENTING

(102 mm)

ft. (2.4 m).

Exhaust hoods:

Must be at least 12" (305 mm) from ground or any object

that may obstruct exhaust (such as owers, rocks, bushes,

or snow).

Recommended Styles:

Louvered hood

Acceptable Style:

Angled hood

Elbows:

45° elbows provide better air ow than 90° elbows.

Good

Clamps:

Use clamps to seal all joints.

Exhaust vent must not be connected or secured with screws

or other fastening devices that extend into interior of duct

and catch lint. Do not use duct tape.

See "Venting Kits" for more information.

Box hood

Better