Whirlpool 7MWGD1860EM Manuale d'uso e manutenzione - Pagina 23
Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Asciugatrice Whirlpool 7MWGD1860EM. Whirlpool 7MWGD1860EM 24. Electric or gas
Stampa la pagina
Troubleshooting
First try the solutions suggested here or consult the warranty sheet in the washer
If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
Latin America Service
For other countries in Latin America, see our Warranty Card
Latin America and visit our Whirlpool Latinoamerica website
www.whirlpool-latam.com.
for assistance and to possibly avoid a service call.
Possible Causes
Automatic cycle ending early.
Lint screen clogged
Dryer fabric softener not properly
used
Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
The electric dryer is being used for
the first time.
Laundry items removed from the
dryer before the end of the cycle.
A high temperature cycle was used,
or a separate temperature control
was set on high.
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic Cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Shield feature to tumble the load without heat to
avoid wrinkling.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
Select a lower temperature and use an Automatic Cycle. These
cycles sense the temperature or the moisture level in the load
and shut off when the load reaches the selected dryness. This
reduces overdrying.
Servicio - America Latina
Para otros países de Latinoamerica, consulte
nuestro Certificado de Garantia Latinoamerica y
visite nuestra página web de Whirlpool Latinoamerica
www.whirlpool-latam.com seleccione su país y luego
Menú Atención al Cliente.
Solution
23