Whirlpool 8533582 Manuale d'uso e manutenzione - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Asciugatrice Whirlpool 8533582. Whirlpool 8533582 24. Duet electronic electric dryer

Stampa la pagina

Location Requirements

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the

floor for a garage installation.

Failure to do so can result in death, explosion,

or fire.

You will need

A location that allows for proper exhaust installation. See

"Venting Requirements."

A separate 30 amp circuit.

A grounded electrical outlet located within 2 ft (61 cm) of

either side of the dryer. See "Electrical Requirements."

A sturdy floor to support the total dryer weight of 200 lbs

(90.7 kg). The combined weight of a companion appliance

should also be considered.

A level floor with a maximum slope of 1 in. (2.5 cm) under

entire dryer. If slope is greater than 1 in. (2.5 cm), install

Extended Dryer Feet Kit, Part Number 279810. Clothes may

not tumble properly and automatic sensor cycles may not

operate correctly if dryer is not level.

For a garage installation, you will need to place the dryer at

least 18 in. (46 cm) above the floor. If using a pedestal, you

will need an additional 6 in. (15.24 cm).

Do not operate your dryer at temperatures below 45ºF (7ºC). At

lower temperatures, the dryer might not shut off at the end of an

automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will

be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,

installation of the dryer in garages, closets, mobile homes, or

sleeping quarters. Contact your local building inspector.

Installation clearances

The location must be large enough to fully open the dryer

door.

Additional spacing should be considered for ease of

installation and servicing.

Additional clearances might be required for wall, door and

floor moldings.

Additional spacing of 1 in. (2.5 cm) on all sides of the dryer is

recommended to reduce noise transfer.

Companion appliance spacing should also be considered.

Dryer Dimensions

*Most installations require a minimum 5½ in. (14 cm) clearance

behind the dryer for the exhaust vent with elbow. See "Venting

Requirements."

Minimum installation spacing for custom undercounter

installation

The dimensions shown are for the minimum spacing allowed.

Custom undercounter installation - Dryer only