Backyard Creations 259-5091 Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Riscaldatore per patio Backyard Creations 259-5091. Backyard Creations 259-5091 14. Outdoor patio heater

OPERATING INSTRUCTIONS

LIGHTING:

TO TURN ON THE HEATER

1. Turn the control knob to the "OFF" position.

2. Fully open the LP cylinder valve.

3. Press and turn the control knob to "HI" position (counterclockwise 90°). Press down the control

knob and hold for 3-5 seconds. While holding down the control knob, press the igniter several

times until the flame ignites. Hold the control knob in for about 30 seconds and release.

4. To decrease the flame, turn the control knob counterclockwise to "LO" position; to increase the

flame, turn the control knob clockwise to "HI" position.

Note: If the flame does not light or goes out, repeat Step 3.

WARNING: FOR YOUR SAFETY: If at any time you are unable to light the burner and smell gas, wait 5 minutes to allow gas

to dissipate before attempting to light heater. If after 1 minute, you are unable to light burner, wait 5 minutes and allow

flammable vapors to dissipate before attempting to light heater again.

NOTE: If a new tank has just been connected, please allow at least one minute or more for the air in the gas line to purge

out through the hole, or simply complete Step 3. When lighting the heater make sure that the control knob is continuously

depressed while pressing the igniter button. Control knob can be released after the flame has been lit for 20~30 seconds.

Flame can be watched and checked from the peephole located on the base of burner. If the flame does not light or it goes

out, repeat Step 3. If the burner flame goes out accidentally or it is blown out by wind, turn off the heater and wait at least 5

minutes or more to let the gas dissipate before relighting to avoid possible gas explosion. Repeat steps as listed above.

TO TURN OFF THE HEATER

1. Turn the control knob to "HI" position.

2. Press and turn the control knob clockwise to "OFF" position.

3. Turn the gas cylinder valve to OFF or CLOSED and disconnect the cylinder.

If you experience any ignition problems, please consult the "Troubleshooting" section of this manual.

Caution: Avoid inhaling fumes emitted from the heater's first use. Smoke and

odor from the burning of oils used in the manufacturing will appear. Both smoke

and odor will dissipate after approximately 30 minutes. The heater should NOT

produce thick black smoke.

WHEN HEATER IS ON:

Emitter screen will become bright red due to intense heat. The color is more visible

at night. Burner will display tongues of blue and yellow flame. These flames should

not be yellow or produce thick black smoke, indicating an obstruction of airflow through the burners. The flame should be

blue with straight yellow tops. If excessive yellow flame is detected, turn off heater and consult the "Troubleshooting"

section of this manual.

RE-LIGHTING:

Note: For your safety, control knob cannot be turned OFF without first depressing the control knob and then rotating to OFF.

1. Turn control knob to "OFF" position.

2. Wait at least 5 minutes to allow gas to dissipate before re-lighting.

3. Repeat the "Lighting" steps as listed above.

WARNING

FOR YOUR SAFETY

Be careful when attempting to manually ignite

this heater. Holding in the control knob for

more than 10 seconds before igniting the gas

will cause a ball of flame upon ignition.