Whirlpool Cabrio,- WED7300X Manuale di installazione - Pagina 5

Remove packing tray from drum

Remove tape from washer lid, open lid and remove cardboard

packing tray from tub. Be sure to remove all parts from tray.

NOTE: Keep tray in case you need to move washer later.

Free power cord

Firmly grasp power cord plug and pull to free from rear panel.

Gently place power cord over console to allow free access

to back of washer.

CONNeCT DraIN hOse

Attach drain hose to drain port

If clamp is not already in place on elbow end of drain hose,

slide it over end as shown. Squeeze clamp with pliers and

slide black elbow end of drain hose onto black drain port

and secure with clamp.

For a laundry tub or standpipe drain, go to step 6.

For a floor drain, remove the preinstalled drain hose form as

shown in Step 7. You may need additional parts with separate

directions. See "Tools and Parts".

Place drain hose in standpipe

Drain

hose form

4.5"

(113 mm)

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 4.5" (113 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.