Whirlpool CGM2743BQ Manuale di istruzioni per l'installazione - Pagina 17
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Asciugatrice Whirlpool CGM2743BQ. Whirlpool CGM2743BQ 48. Commercial dryer gas or electric
Anche per Whirlpool CGM2743BQ: Manuale di istruzioni per l'installazione (48 pagine)
Stampa la pagina
INSTALLING LEVELING LEGS, COIN SLIDE,
AND COIN BOX
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1. Prepare dryer for leveling legs
NOTE: Slide dryer onto cardboard or hardboard before moving
to avoid damaging floor covering.
Using two or more people, move dryer to desired installation
location.
Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe drum interior with a
damp cloth to remove any dust.
Take two cardboard corners from the dryer carton and place
them on the floor in back of the dryer. Firmly grasp the body of
the dryer and gently lay it on its back on the cardboard corners.
On some models: The meter case houses the factory-installed
accumulator
timer with actuating arm or service switch.
The factory-installed
timer is set to provide 45 minutes (4 pins)
of drying time when activated by the coin slide. Timer cams
for 30-minute
(6 pins) and 60-minute (3 pins) drying times are
included in the parts bag.
The coin slide mechanism, service door lock and key, and coin
box lock and key may not be included but are available from
the usual industry sources.
1. install coin slide and coin box
Remove the service door of the meter case by lifting it up
at the back. install the money-accepting
device. (Refer to
manufacturer's
instructions
for proper installation.)
(appearance
may vary)
2. Screw in leveling legs
Examine leveling legs and find diamond
marking. Screw legs into leg holes by
hand. Use an adjustable wrench or
1" (25 ram) hex-head socket wrench
to finish turning legs until diamond
marking is no longer visible. Then fit
a covered foot boot over each leg foot.
Diamond
Marking_
Foot
To protect the floor, use a large piece of cardboard from the
dryer carton. Stand dryer up on the cardboard. Slide the dryer
until it is close to its final location. Leave enough room for
electrical connection
and to connect the exhaust vent.
For dryers using coin slides, use the adapter kit supplied with
the dryer.
Replace the meter case service door. Put the coin vault with
lock and key in the meter case opening.
Remove cardboard or hardboard from under dryer. Adjust the
legs of the dryer up or down until the dryer is level.
2. install added security
device
Check that power is not supplied to the dryer.
Open and remove the service door.
insert the narrow part of the security cone into the oblong hole
in the bottom rear of the meter case assembly.
Pass the security bolt through this cone and thread it by hand
into the cage nut below the oblong hole.
Tighten the security bolt by hand a few turns before using a
wrench to tighten until snug.
Bolt
Cone
Cage
Nut
NOTE: installing the security bolt provides added security, but
will add to the service time when the top needs to be removed
for servicing the dryer.
17