Whirlpool GEW9868KQ Manuale di istruzioni per l'installazione - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Asciugatrice Whirlpool GEW9868KQ. Whirlpool GEW9868KQ 7. Installation instructions
Stampa la pagina
14-30R
Four-wire
receptacle
(required
for
mobile
homes)
Direct
wire cable must have
four feet of extra
length
so
dryer
can be moved
if needed+
Strip 5 inches
of outer +covering
from
end of cable+ Leave bare
ground
wire at 5 inches.
Cut
1+1/2 inches
from
3 remaining
wires+ Strip insulation
back
1 inch,
+r)
4. Remove center terminal block screw.
"X
5. Remove appliance ground wire (green
with yellow stripes) from external ground
connector screw. Fasten under center,
6. Connect the ground wire
_
silver-colored terminal
block screw.
(bare) of the power supply
_
/
cable to the external ground
__
_
/
conductor"
screw. Tighten
_'
n
n
n
d
screw,
[
_
__
_Lr_
/
/
. ....
-,
_
of the neutral wire (white
//
_
_
or" center) of power
8. Place the hooked ends of the
s
y
'
upply cable under the
other power supply cable wires
center screw of terminal
under the outer terminal block
block (hook facing right).
screws (hook facing right). Squeeze
Squeeze hook end
hooked ends together. Tighten
together: Tighten screw.
screws.
9. Tighten strain relief screws.
10,
Insert tab of terminal
block cover
into slot of dryer rear panel. Secure cover
with hold-down
screw.
10-30R Three-wire
receptacle
5o Connect the neutral wire (white
or center) of power supply cord to
the center, silver+colored terminal
screw of the terminal
block.
Tighten screw.
6. Connect the other
N
wires to outer terminal
k'
block screws. Tighten
screws.
7. Tighten strain relief
screws,
8, Insert tab of terminal
block
cover
into siot of dryer
rear panel
Secure
cover with
hold-down
screw,
HH++
D+rect
wire c able must have
four feet of extra length so
dryer can be moved if needed.
Strip 3-1/2 inches of outer
covering from end of cable,
Strip insulation back 1 inch. If
using 3-wire cable with
ground wire, cut bare wire
even with outer covering.
. wire
• (:enter)
WhereIota[ cedes permit
connecting
cabinet=ground
conductor
to neutraJ wire:
4,
Loosen or remove center terminal
block screw.
5. Place the hooked end of the
\\
neutral wire (white or center)
power supply cable under the
center screw of the terminal
b!ock (hook facing right).
Squeeze hooked end together.
Tighten screw.
6. Place the hooked ends of
the other power supply cable
wires under the outer terminal
._ .... .,
block screws (hook facing
,
,
right). Squeeze hooked ends
together. Tighten screws.
7, Tighten strain relief screws.
8. Insert tab of termina! block cover
into slot of dryer rear panel+ Secure
cover with hold-down
screw.
Panel B