Whirlpool Gold GGQ9800PG Istruzioni per l'utente - Pagina 6

Sfoglia online o scarica il pdf Istruzioni per l'utente per Asciugatrice Whirlpool Gold GGQ9800PG. Whirlpool Gold GGQ9800PG 16.

Stampa la pagina

1. Table of Contents

AsNeeded Cleaning

1. Roll l intoffthescreen withyour

f ingers.

2. Wet both sides of lint screen with hot weten

3. Wet a nylon brush with hot water and liquid detergent. Scrub

lint screen with the brush to remove residue buildup.

Rinse screen with hot weten

5. Thoroughly dry lint screen with a clean towel. Replace screen

in dryer.

Cleaningthe DryerInterior

1. Apply a nonflammable houashold clasner to the stained area

of the drum and rub with a soft cloth until stain is removed.

2. Wipe drum thoroughly with a damp cloth.

3. Tumble a Ioed of clean cloths or towels to dry the drum.

NOTE: Garments which contain unstable dyes, such as denim

blue jeans or brightly colored cotton items, may discolor the dryer

interion These stains are not harmful to your dryer and will net

stain future loads of clothes. Dry unstable dye items inside-out to

prevent dye transfa_

RemovingAccumulatedLint

From Inside 111o Dryer Cabinet

Lint should be removed every 2 years, or more often, depending

on dryer usage. Cleaning should be done by a qualified person.

From Inside the Exhaust Vent

Lint should be removed every 2 years, or more often, depending

on dryer usage.

Changingthe DrumLight

1. Unplug dryer or disconnect powen

2. Open the dryer doon Locetethe light bulb cover on the back

wall of the dryer. Remove the screw located in the lower right-

hand corner of the cover. Remove the coven

3. Turn bulb counterclockwias.

Replsce the bulb with a 10-watt

appliance bulb only. Replace the cover and secure with the

SCreW,

Plug in dryer or reconnect powen

TROUBLESHOOTING

First tW the solutions suggested hem and possibly •void the cost of a service call...

Dryer O peration

Message

Codes - Electronic

models

only

For error message "PF" (power failure), check the

following:

Is the dryer connected to the power supply?

Was the dryer connected to a power supply during installation

or a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

Was the drying cycle interrupted by a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

For error message "El"

or "F.2" (service codas):

Service is required. Call for service.

Dryer will not run

Check the following:

Is the power cord plugged in?

Has a fuse blown, or has a circuit breaker tripped? There

may be 2 fuses or circuit breakers for the dryer, Check to

make sure beth fuses are intact and tight, or thet beth circuit

breakers have not tripped,

Was a regular fuse used? Use a time-delay fuse,

Is the dryer door firmly closed?

Was the START pad firmly pressed?

Is a cycle selected?

No heat

Has a fuse blown, or has a circuit breaker tripped? Electric

dryers use 2 household fuses or breakers, The drum may be

turning, but you may not have heat,

•

Has an air dry cycle been selected? Select the right cycle

for the types of garments being dried.

•

For gas dryers, is the valve open on the supply line?

Unusual sounds

•

Has the dryer had a period of non-use? If the dryer hasn't

been used for a while, there may be a thumping sound during

the first few minutes of operation.

•

Is it a gas dryer?. The gas valve clicking is a normal operating

sound.

Dry u]ts

Clothes are not drying setisfactodly

•

Check the following:

Is the lint screen clogged with lint?

ms the exhaust vent or outside exhaust hood clogged with

mint,

restricting air movement? Run the dryer for 5-10 minutes.

Hold your hand under the outside exhaust hood to check air

movement. If you do net feel air movement, clean exhaust

system of lint or replace exhaust vent with heavy metal or

flexible metal vent. See your Installation Instructions.

ms the exhaust vent crushed or kinked? Replace with heavy

metal or flexible metal vent. See your Installation Instructions.

Are fabric softener sheets blocking the grille? Use only one

fabric softener sheet, and use it only once.

ms the dryer located in a room with temperature

below

45°F ('PC)? Proper operation of dryer cycles requires

temperatures above 45°F (7°C).

Was a cold rinse water used? Was the load very wet?

Expect monger d rying times with items rinsed in cold water and

with items that hold moisture (cottons),

Isthe loadtoo large and heavy to dry quickly?. S eparatethe

mead to tumblefreely.