Whirlpool WGD7600XW0 Manuale di istruzioni per l'installazione - Pagina 14
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Asciugatrice Whirlpool WGD7600XW0. Whirlpool WGD7600XW0 32. 27" gas dryer
Anche per Whirlpool WGD7600XW0: Manuale di istruzioni per l'installazione (32 pagine)
Stampa la pagina
3. Reinstall the door strike and cosmetic screw on the opposite
side of dryer door opening from where they were removed.
NOTE: Door strike and plugs must be on the same side
of the dryer door opening.
Reinstall the door
1. Remove the 4 screws and 2 hinges from the dryer door.
2. Replace the 4 screws in the same holes.
3. Remove the 4 screws from the opposite side of the door.
4. Install the 2 hinges to the front panel of the dryer using
4 screws. Use the non-slotted side to attach the hinge
to the front panel.
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer Operation
Dryer will not run
■
Has a household fuse blown, or has a circuit breaker
tripped?
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
■
Is the correct power supply available?
Electric dryers require 240-volt power supply. Check with
a qualified electrician.
■
Was a regular fuse used?
Use a time-delay fuse.
14
TROUBLESHOOTING
5. Install screws in top hinge holes in the door. Do not tighten
screws. Leave approximately 1/4" (5 mm) of screw exposed.
6. Hang door by placing screw heads into top slotted holes
of hinges and slide door down. Align bottom screw holes
in hinge and door. Install two bottom screws. Tighten
all hinge screws.
7. Close door to engage door strike.
No heat
■
Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Dryer displaying code message
■
"PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START/PAUSE to restart the dryer.
Try the following:
Check to see if a household fuse has blown or circuit breaker