Whirlpool WGD97HEXW0 Manuale di istruzioni per l'installazione - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Asciugatrice Whirlpool WGD97HEXW0. Whirlpool WGD97HEXW0 38. Gas dryer
Anche per Whirlpool WGD97HEXW0: Manuale d'uso e manutenzione (36 pagine)
Stampa la pagina
Optional E quipment: ( Not s upplied w ithdryer)
Refer toyourUse andCare Guide f orinformation about
accessories available foryourdryer.
Explosion Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from dryer,
Place dryer at least 18 inches (460 rnm) above the floor
for a garage installation,
Failure to do so can result in death, explosion, or fire,
You will need:
[] A location allowing for proper exhaust installation.
See "Venting Requirements."
[] A separate 15 or 20 amp circuit for a gas dryer or 30 amp
circuit for an electric dryer.
[] If using power supply cord, a grounded electrical outlet
located within 2 ft. (610 mm) of either side of dryer.
See "Electrical Requirements."
[] Floor must support dryer weight of 200 Ibs. (90.7 kg).
Also consider weight of companion appliance.
[] Cold water faucets located within 4 ft. (1.2 m) of the water fill
valves, and water pressure of 20-100 psi (137.9-689.6
kPa).
You may use the water supply for your washer using the "Y"
connector and short hose (if needed) which are provided.
[] 20-100 psi (138-690 kPa) for best performance.
[] Level floor with maximum slope of 1" (25 mm) under entire
dryer. If slope is greater than 1" (25 mm), install Extended
Dryer Feet Kit, Part Number 279810. If not level, clothes
may not tumble properly and automatic sensor cycles may
not operate correctly.
[] For garage installation, place dryer at least 18" (460 mm) above
floor. If using a pedestal, you will need 18" (460 mm) to bottom
of dryer.
[] The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
For each arrangement,
consider allowing more space for ease
of installation and servicing; spacing for companion
appliances
and clearances for walls, doors, and floor moldings. Space
must be large enough to allow door to fully open. Add spacing
on all sides of dryer to reduce noise transfer. If a closet door
or Iouvered door is installed, top and bottom air openings
in door are required.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning
appliance can be installed in the
same closet as a dryer.
DRYER DIMENSIONS
Front view:
381/8
H
(968 ram)
t
(18 ram)
(686 ram)
©
©
* Approx.
measurement
Side view:
50¼"
(1292 ram)
53/4
H_
(146 ram}
I
31/2"
* Approx.
measurement
Back view:
53/4
H_
(146 ram}
297/8.*
(759 ram}
(156 ram)
(654 ram)
* Approx.
measurement
NOTE: Most installations
require a minimum of 5" (127 mm) clearance
behind dryer for exhaust vent with elbow. See "Venting Requirements."