Whirlpool YWED7500VW Manuale d'uso e manutenzione - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Asciugatrice Whirlpool YWED7500VW. Whirlpool YWED7500VW 36.
Stampa la pagina
Tools and Parts
Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Flat-blade screwdriver
Adjustable wrench
T20 TORX
screwdriver
®†
Caulking gun and
compound (for installing
new exhaust vent)
Parts supplied
Remove parts package from the dryer drum. Check that all parts
listed are included.
Parts needed
Check local codes, existing electrical supply and venting, and
see "Venting Requirements" and "Electrical Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system
hardware. For ordering information, please refer to the
"Assistance or Service" section of this manual. You may also
contact the dealer from whom you purchased your dryer.
Options
Pedestal
You may order a pedestal separately for this dryer. This pedestal
will add about 12" (305 mm) to the height of your unit for a total
height of approximately 45" (1143 mm).
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Model Number LAB0050PQ.
†®TORX is a registered trademark of Acument Intellectual Properties, LLC.
INSTALLATION REQUIREMENTS
Tin snips (new vent
installations)
Wood block
Level
Vent clamps
Coupling
Stack Kit
Are you planning to stack your washer and dryer? Your dryer is
shipped with Stack Kit W10178021A, which fits Whirlpool washer
models starting with WFC.
If you have a Whirlpool washer model starting with LHW, use
Stack Kit 8182452. If you have any other washer model, call the
dealer from whom you purchased your dryer or refer to the
"Assistance or Service" section of this manual.
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
You will need
A location that allows for proper exhaust installation. See
"Venting Requirements."
A separate 30-amp circuit.
A grounded electrical outlet located within 2 ft (61 cm)
of either side of the dryer. See "Electrical Requirements".
A sturdy floor to support the dryer weight (dryer and load)
of 115 lbs (52 kg). The combined weight of a companion
appliance should also be considered.
A level floor with a maximum slope of 1" (25 mm) under
entire dryer.
Do not operate your dryer at temperatures below 45ºF (7ºC).
At lower temperatures, the dryer might not shut off at the end
of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
5