Calandra Racing Concepts Carpet Knife Generation X 10 Manuale di montaggio - Pagina 2

Sfoglia online o scarica il pdf Manuale di montaggio per Auto giocattolo motorizzata Calandra Racing Concepts Carpet Knife Generation X 10. Calandra Racing Concepts Carpet Knife Generation X 10 19.

Stampa la pagina
Center Pivot
Bag 1
Using a hobby knife, or Dremel tool, trim the plastic pivots [1] as shown. This
gives added motor and battery clearance.
Assemble the Center Pivot assembly as shown in Figure 2. Tighten the 2-56
flat heads [2] enough to remove any up and down play, be sure the flanged
pivot ball [4] pivots freely.
1
Trim plastic
pivot pieces
using the dotted
lines as a guide.
Before trim
Center Pivot
4-40 x 3/8" FH Steel
Bag 1
9
8
7
5
Plastic pivots
1
After trim
1
4-40 Thin Hex Nut
5
2-56 Flat Head
2
2
7
8
1 - Place the 4-40 x 3/8" screws [5] through the graphite chassis [6] in
the holes shown. Tighten a 4-40 thin hex nut [7] down fairly tight.
2 - Then, after both thin hex nuts are tight on the 2 mounting screws,
drop the assembled pivot plate over the screw posts.
3 - Drop a washer [8] over each screw above the pivot plate assembly.
4 - Thread on the 4-40 red locknuts [9]. Do not tighten them yet as we
will adjust this later.
6
4
Graphite "football"
shaped piece.
(American Football)
Washer
Red Locknut
9
Alum Pivot ball
4
2
3
1