Whirlpool (91.) BUILT-IN Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Cappa di ventilazione Whirlpool (91.) BUILT-IN. Whirlpool (91.) BUILT-IN 16. 36" (91.4 cm) gas built-in cooktop
Anche per Whirlpool (91.) BUILT-IN: Manuale di installazione e uso (24 pagine)

Stampa la pagina

1. Installation Instructions

Tools and Parts

Gather the required tools and parts before starting installation.

Tools needed

Tape measure

Flat-blade screwdriver

" combination wrench

Pipe wrench

Channel lock pliers

Parts supplied

Gas pressure regulator

Burner grates

Burner heads and caps

Clamp brackets (2)

2 " (6.4 cm) clamping screws (2)

Foam tape seal

Parts needed

Check local codes and consult gas supplier. Check existing gas

supply and electrical supply. See "Electrical Requirements" and

"Gas Supply Requirements" sections.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Do

not obstruct flow of combustion and ventilation air.

It is the installer's responsibility to comply with installation

clearances specified on the model/serial rating plate. The

model/serial rating plate is located on the underside of the

cooktop burner box.

To eliminate the risk of burns or fire by reaching over heated

surface units, cabinet storage space located above the

surface units should be avoided. If cabinet storage is to be

provided, the risk can be reduced by installing a range hood

that projects horizontally a minimum of 5" (12.7 cm) beyond

the bottom of the cabinets.

The cooktop should be installed in a location away from

strong draft areas, such as windows, doors and strong

heating vents or fans.

All openings in the wall or floor where cooktop is to be

installed must be sealed.

Cabinet opening dimensions that are shown must be used.

Given dimensions are minimum clearances.

Grounded electrical supply is required. See "Electrical

Requirements" section.

Proper gas supply connection must be available. See "Gas

Supply Requirements" section.

The gas and electric supply should be located as shown in

"Gas and Electric Connection Locations" in the "Location

Requirements" section so that they are accessible without

requiring removal of the cooktop.

INSTALLATION REQUIREMENTS

Marker or pencil

Pipe-joint compound

resistant to LP gas

Noncorrosive leak-detection

solution

IMPORTANT: To avoid damage to your cabinets, check with your

builder or cabinet supplier to make sure that the materials used

will not discolor, delaminate or sustain other damage.

Mobile Home - Additional Installation Requirements

The installation of this cooktop must conform to the

Manufactured Home Construction and Safety Standard, Title 24

CFR, Part 3280 (formerly the Federal Standard for Mobile Home

Construction and Safety, Title 24, HUD Part 280). When such

standard is not applicable, use the Standard for Manufactured

Home Installations, ANSI A225.1/NFPA 501A or with local codes.

In Canada, the installation of this cooktop must conform with the

current standards CAN/CSA-A240-latest edition, or with local

codes.

Product Dimensions

A. 36" (91.4 cm)

B. 20 " (51.1 cm)

C. 2

Gas and Electric Connection Locations

A. Gas pressure regulator (supplied) -

arrow pointed toward cooktop

B. 3 prong grounding type outlet with

correct polarity

C. 18" (45.7 cm) minimum

D. Gas shutoff valve

" (7.2 cm)

C L