Whirlpool 30 " Eye-Level Gas Range Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 4

Stampa la pagina

1. Installation Requirements

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Level

Drill

" (3 mm) drill bit

Pencil

Pliers

Tape measure or ruler

Caulking gun and weatherproof caulking compound

Phillips screwdriver

Flat-blade screwdriver

Saber or keyhole saw

Vent clamps

Metal snips

Parts needed

6" (15.2 cm) round metal vent system

For vented installations, you will need:

1 wall or roof cap

For non-vented (recirculating) installations, you will also

need:

Recirculation Kit Part Number W10490330. See the

"Assistance or Service" section to order.

Parts supplied

Remove parts from packages. Check that all parts are included.

Damper

Hardware package. Includes:

Installation Instructions and Use and Care Guide

2 mounting brackets

6 spacers

10 - 4.5 x 13 mm wood screws

2 - 4.2 x 15 mm machine screws

4 - 3.5 x 9.5 mm flat-head sheet metal screws

8 - 4.2 x 19 mm sheet metal screws

2 - 3.5 x 9.5 mm sheet metal screws

1 - 30" x 12" (76.2 x 30.5 cm) face panel

2 metal grease filters

®†

T10 TORX

adapter

8 - metal washers

8 - plastic washers

†®TORX is a registered trademark of Saturn Fasteners, Inc.

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the

installer's responsibility to comply with installation clearances

specified on the model/serial rating plate. The model/serial rating

plate is located inside the liner behind the filter on the left wall of

the range hood.

Range hood location should be away from strong draft areas,

such as windows, doors, and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance. Consult your cooktop/

range manufacturer installation instructions before making any

cutouts.

Grounded electrical outlet is required. See "Electrical

Requirements" section.

The range hood is factory set for vented installations through the

roof or wall. For non-vented (recirculating) installations see "Non-

Vented (recirculating) Installation Through the Soffit/Cabinet" in

the "Prepare Location" section. Recirculation Kit Part Number

W10490330 is available from your dealer or an authorized parts

distributor.

All openings in ceiling and wall where range hood will be installed

must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the

Manufactured Home Construction Safety Standards, Title 24

CFR, Part 328 (formerly the Federal Standard for Mobile Home

Construction and Safety, title 24, HUD, Part 280) or when such

standard is not applicable, the standard for Manufactured Home

Installation 1982 (Manufactured Home Sites, Communities and

Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local

codes.