Whirlpool 30 " Eye-Level Gas Range Manuale di istruzioni per l'installazione - Pagina 3

Stampa la pagina

Cabinet Side View

A. 23¹⁄₄" (59.1 cm) min. cutout depth

B. 23" (58.4 cm) recessed microwave oven depth

C. Oven front

D. Recessed oven

E. Cabinet

Electrical Requirements

GROUNDING INSTRUCTIONS

For a permanently connected microwave oven:

The microwave oven must be connected to a grounded,

metallic, permanent wiring system, or an equipment

grounding conductor should be run with the circuit

conductors and connected to the equipment grounding

terminal or lead on the microwave oven.

SAVE THESE INSTRUCTIONS

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrical installer determine that

the ground path and wire gauge are in accordance with local

codes.

Check with a qualified electrical installer if you are not sure the

microwave oven is properly grounded.

This microwave oven must be connected to a grounded metal,

permanent wiring system.

Be sure that the electrical connection and wire size are adequate

and in conformance with the National Electrical Code, ANSI/

NFPA 70-latest edition or CSA Standards C22.1-94, Canadian

Electrical Code, Part 1 and C22.2 No. O-M91-latest edition, and

all local codes and ordinances.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

Electrical Connection

To properly install your microwave oven, you must determine the

type of electrical connection you will be using and follow the

instructions provided for it here.

Microwave oven must be connected to the proper electrical

voltage and frequency as specified on the model/serial

number rating plate. The model/serial number rating plate is

located on the right-hand microwave oven frame.

A. Model/serial number plate

When a 4-wire or 3-wire, single phase 120/208 or 120/240

volt, 60 Hz, AC only electrical supply is available, a 20-amp

maximum circuit protection is required, fused on both sides

of the line.

NOTE: Models KBHC109, KBHC179, YKBHC109 and

YKBHC179 require a 30-amp circuit.

A time-delay fuse or circuit breaker is recommended.

Connect directly to the fused disconnect (or circuit breaker

box) through flexible, nonmetallic sheathed, copper cable

(with grounding wire). See "Make Electrical Connection"

section.

Flexible cable from the microwave oven should be connected

directly to the junction box.

Do not cut the conduit. The length of conduit provided is for

serviceability of the microwave oven.

A UL listed or CSA approved conduit connector must be

provided.

If the house has aluminum wiring follow the procedure below:

1. Connect a section of solid copper wire to the pigtail

leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.