Whirlpool 30 " Eye-Level Gas Range Manuale di installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione per Cappa di ventilazione Whirlpool 30 " Eye-Level Gas Range. Whirlpool 30 " Eye-Level Gas Range 7. Freestanding gas range with self-cleaning oven
Anche per Whirlpool 30 " Eye-Level Gas Range: Istruzioni per l'installazione e manuale d'uso e manutenzione (32 pagine), Manuale di istruzioni per l'installazione (11 pagine), Istruzioni per l'installazione e manuale d'uso e manutenzione (28 pagine), Manuale di istruzioni per l'installazione (11 pagine), Istruzioni per l'installazione (5 pagine), Manuale di istruzioni per l'installazione (28 pagine), Manuale di istruzioni per l'installazione (48 pagine), Manuale di istruzioni per l'installazione (32 pagine), Manuale di istruzioni per l'installazione (12 pagine), Istruzioni per l'installazione (5 pagine), Manuale di istruzioni per l'installazione (7 pagine), Manuale di istruzioni per l'installazione (7 pagine), Istruzioni per l'installazione (5 pagine), Manuale di istruzioni per l'installazione (7 pagine), Manuale di istruzioni per l'installazione (10 pagine)

Stampa la pagina
Whirlpool 30
9
Remove storage drawer.
.
Assemble the flexible
connector
from the gas supply pipe
to the pressure regulator
in this order:
314' nipple. 314' to l/2' reducer,
l/2
nipple, manual shutoff valve, l/2'
nipple. union. and 112" nipple.
IO-
Use pipe-joint
compound
. resistant to the action of L.P.
gas to seal all gas connections,
Check that the shutoff valve is open
between
the regulator
and gas
valves.
If flexible connectors
are
used. be certain connectors
are not
kinked,
11
Open the shutoff valve in
. the gas supply line. Wait a
few minutes for gas to move through
the gas line,
12
Use a brush and liquid
. detergent
to test all gas
connections
for leaks. Bubbles
around ConnectIons
will indicate
a
leak. If a leak appears,
shut off gas
valve controls and adiust
connections,
Then check
connedons
again. NEVER TEST FOR
GAS LEAKS WlTH A MATCH OR
OTHER FLAME. Clean all detergent
solution from range.
Electronic
Ignition System
Electronic ignition systems operate
within wide voltage
limits. but proper
grounding
anU polarity is necessary
In addition
to checking
that the
outlet provides
120~volt power and IS
correctly
grounded.
the outlet must
be checked
by a qualified
electrician
to see if it
is wired with
correct
polarity.
Cooktop
and oven burners use
electronic
igniters in place of
standing pilots. When the cooktop
control is turned to the 'LITE'
position, the system creates a spark
to light the burner. This sparkmg
continues
until the control is turned
to the desired setting. When the
oven control is turned to the desired
setting, a glow bar heats up bright
orange and ignites the gas. No
sparking occurs and the
glow bar remains on
while the burners
operate.
13.
Check the
operation
of the
cooktop
burners. Push in and turn
each control knob to 'LITE- oosition
The flame should light within'4
seconds.
DO Not leave
the
knob in
Ihe 'LlTE" position after burner lights.
14
After burner lights. turn
I control knob to "HI'
position. Check each cooktop
ourner for proper flame. The small
inner cone should have a verv
distinct blue flame l/4' to l/Z' long
The outer cone is not as distinct as
the inner cone.
H
15
'
If burners need adjusting for
. proper flame, adjust the air
shutter to the widest opening that
will not cause the flame to litt or blow
off the burner. Repeat as necessary
with each burner.
Check the
Check the
operation
of
operation
of
the lower oven
the lower oven
burner. Push in and
burner. Push in and
turn the oven control knob to 300°F.
turn the oven control knob to 300°F.
The oven burner should lighl in
50
lo
The oven burner Should lighl in 50 lo
60 SMCndS. Thls delay is normal. The
60 SMCndS. This delay is normal. The
oven safety valve requires a certain
oven safety valve requires a certain
time before it will open and allow
gas to flow
rime before it will open and allow
gas to flow
PANEL C