Whirlpool 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 9

Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso e manutenzione per Cappa di ventilazione Whirlpool 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD. Whirlpool 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD 28.

Stampa la pagina

10. Mount Range Hood

Lift the range hood into place, positioning the rear slots over

the mounting brackets.

Using a Phillips screwdriver, push on the screws that are

started into the top mounting tabs and bend the tabs against

the cabinet side walls. Attach the screws to the cabinet side

walls.

For direct wire installations, run the home power supply cable

according to the National Electric Code or CSA standards

and local codes and ordinances. There must be enough

wiring from the fused disconnect (or circuit breaker) box to

make the connection in the range hood electrical terminal

box.

Tighten the strain relief screws.

NOTE: Do not reconnect power until the installation is

complete.

OPTIONAL: If you prefer, bend the rear tabs against the rear

of the range hood and attach to the wall using #8-18 x ⁵⁄₈"

(4.2 x 16 mm) truss-head screws.

11. Connect Vent System

Connect the ventwork to the range hood. Seal joints with vent

clamps or duct tape to make secure and airtight.

Check that the back draft dampers work properly.

12. Make Electrical Connection

Option 1 - Direct Wire Installations

Use a UL Listed/CSA Approved wire connector and connect

the 2 white wires (A) together.

Use a UL Listed/CSA Approved wire connector and connect

the 2 black wires (B) together.

WARNING

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect ground wire to green ground screw in

terminal box.

Failure to do so can result in death, fire, or

electrical shock.

Connect the green (or bare) ground wire (C) from the power

supply to the green ground screw in the electrical box and

tighten the screw securely.

Reinstall the electrical box cover.

Reconnect power.

Option 2 - Power Cord Kit Installations

For optional power cord kit installations, follow the instructions

supplied with the power cord kit. See the "Assistance or Service"

section for information on ordering.

NOTE: Use only with range hood cord connection kits that have

been investigated and found acceptable for use with this model

range hood.

13. Complete the Installation

Install a 120V, 75W maximum, incandescent light bulb with

E26 base. See "Replacing the Incandescent Light Bulb" in the

"Range Hood Care" section.

If removed previously, replace the filter. See "Metal or Charcoal

Grease Filter" in the "Range Hood Care" section.

For vented installations: Install a metal filter.

For non-vented (recirculating) installations: Install a

charcoal filter.

Check the operation of the range hood fan and light. See the

"Range Hood Use" section.

If the range hood does not operate, check to see whether a

circuit breaker has tripped or a household fuse has blown.

Disconnect the power and check the wiring connections.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.