Whirlpool UXT4136AD Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 7

Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso e manutenzione per Cappa di ventilazione Whirlpool UXT4136AD. Whirlpool UXT4136AD 28. 30" and 36" (76.2 and 91.4 cm) range hood
Anche per Whirlpool UXT4136AD: Istruzioni per l'installazione e manuale d'uso e manutenzione (28 pagine), Istruzioni per l'installazione e manuale d'uso e manutenzione (28 pagine)

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

45˚+

90˚

Hold the range hood firmly in place with one hand and bend each

mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

For a non-vented (recirculating) installation: Go to Step 7.

For a top vented installation: Mark the 4 vent hole locations (C)

on the top of the range hood.

For a rear vented installation: Mark the 4 vent hole locations (D)

on the rear of the range hood.

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

6. Mark and Cut Vent Opening

3¹⁄₄" x 10" (8.3 x 25.4 cm) Rectangular Vent System

Using a ¹⁄₂" (13 mm) drill bit, drill a hole in each of the dots

marked previously on either the wall or upper cabinet. Using

the outside edges of the holes, mark the vent opening.

Using a jigsaw or keyhole saw, cut the vent opening.

7. Drill Electrical Opening

Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a ¹⁄₈" (3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45° angle in an upward direction.