Clare Controls ClareHome CS-iMR WOB Scheda di installazione - Pagina 4

Sfoglia online o scarica il pdf Scheda di installazione per Amplificatore Clare Controls ClareHome CS-iMR WOB. Clare Controls ClareHome CS-iMR WOB 6. Multi-room audio

Stampa la pagina
Figure 4: Attach CS-iMR to the rack mount
Figure 5: Mount in rack
Connecting devices to the CS-iMR
Before connecting devices, install the CLIQ.host in accordance
with the instructions included with the CLIQ.host. See
CLIQ.host Controller Installation Sheet Doc ID 613.
Record each device's MAC address, labeled on the bottom of
each device. Record the UUID for the CLIQ.host. Your system
programmer will need this information when configuring the
CS-iMR.
Note: To configure the iMR flexports, see Using the Sonos
Connect with CobraNet (DOC ID 1308 Rev 01).
To connect the CS-iMR to the CLIQ.host:
1.
Install a ground wire (not included) from the CS-iMR
chassis grounding screw to an external ground. See
Figure 6, item 3.
2.
Connect the Ethernet cable (not included) to the Ethernet
port on the back of the CLIQ.host, and then connect the
other end to the CobraNet switch on the CS-iMR. See
Figure 6, item 5.
3.
Connect your speaker cables to the Speaker Output jacks
using the Euro-style connectors (included). See Figure 6,
item 6.
4 / 6
4.
Connect any input or output devices to the Flexports, as
programmed in ClareHome Fusion. See Figure 6, item 7.
5.
Turn the red switch on CS-iMR to Reset position to start
the amps. See Figure 6, item 4.
Note: The red switch only powers the Amps. All other
switches and the CS-MR-8 are on once plugged in.
Figure 6: CS-iMR WOB and CLIQ.host connections
(1) CS-iMR WOB
(2) CLIQ.host controller
(3) Chasis ground screw
(4) Power switch
To connect the CS-iMR to the CLIQ.mini:
1.
Install a ground wire (not included) from the CS-iMR
chassis grounding screw to an external ground. See
Figure 7, item 3.
2.
Connect an Ethernet cable (not included) to the CobraNet
switch on the CS-iMR. See Figure 7, item 5.
3.
Connect a USB to Ethernet Adapter cable (not included,
p/n TU-2ET100) to the CLIQ.mini USB port 2. See Figure
8, item 2.
4.
Connect the Ethernet cable attached to the iMR to the
Ethernet adapter cable on the CLIQ.mini. See Figure 7,
item 6.
5.
Connect any input or output devices to the Flexports, as
programmed in ClareHome Fusion. See Figure 7, item 8.
6.
Turn the red switch on CS-iMR to Reset position to start
the Amps. See Figure 7, item 4.
Note: The red switch only powers the Amps. All other
switches and the CS-MR-8 are on once plugged in.
(5) Ethernet cable for CobraNet
(6) Speaker outputs
(7) Audio flexports
Doc ID - 1307 • REV 02