Clarinet Systems EtherUSB Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Punto di accesso wireless Clarinet Systems EtherUSB. Clarinet Systems EtherUSB 15. Usb ethernet access point for pda
Stampa la pagina2.2 Hardware Installation
1. Connect the Ethernet cable to the EA104 Ethernet uplink (WAN) and the other
end to Ethernet switch/hub*.
2. Connect PDA to the EA104 USB port**.
3. Connect the power adapter to rear socket of the EA104, then into the wall outlet.
If power is present, the EA104 will proceed with normal power on sequence - self
test and boot up sequence within 25 seconds; once the Power LED is solid in
color on the front panel, the unit is ready.
• If the unit has a problem, the power LED will flash quickly.
• If the network connection has a Link, the Ethernet LED will blink green.
• If USB devices are connected & recognized by the EA104, the
corresponding LED will illuminate on the front panel.
To shut down the EA104, disconnect the AC power adapter. Do not shut down the
EA104 when there is a PDA performing data communications since this may
cause data to be lost.
Notes:
* In a non-DHCP environment, the system administrator must set up an enclosed
DHCP network by accessing the EA104 configuration using the browser-based
AdminTool.
Clarinet Systems, Inc.
http://www.clarinetsys.com
Page 7