AER AG 83 Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti AER AG 83. AER AG 83 16.

Stampa la pagina

4. Starting up

4.1 Cabling and switching on

USA, 230V in Europe). The relevant specs and safety

symbols are printed on the rear side of the unit.

Connect all cables according to your application

and switch the amplifier on. The green power con-

trol LED indicates operational readiness.

4.2 Level adjustment for the use as a

monitor speaker

The level of monitor or sound reinforcement

speakers is usually adjusted by the mixing console.

For this application the following basic settings of

the AG8

are recommended:

• line, bass, treble, master in center position

• mic and aux fully anticlockwise

If these settings are used, the input voltage at

line in for rated output power will be 1 V.

4.3 Level adjustment for use as

amplifier system

Initially, keep the master control fully anticlockwise.

Now adjust the appropriate input level control (line,

mic, or aux) clockwise as far as possible, but without

triggering the red clip indicator while you play.

If several inputs are used simultaneously, the input

controls also determine the desired mixing ratio of

the individual sources. Also check the clip indicator

while playing through all inputs at the same time.

Level controls of any unused inputs should be set

fully anticlockwise.

After setting up the input levels you can adjust the

overall volume with the master control.

Before connecting to

mains, please ensure

that your local mains

voltage is suitable

for the voltage of the

device (e.g. 120V in the

ground lift

• The input level controls adapt the AG 8

different sources in order to get the best possible

reproduction.

• If the input level setting is too low, the AG 8

not reach the full volume or the signal to noise

ratio will be worse.

• Setting the input level too high causes distorted

sound. The clip indicator will warn you before this

happens.

• If you use an instrument with a volume control,

start off with full volume but reduce it if the clip

indicator lights up early and adjusting the input

level is difficult.

• Please ensure there is always enough battery po-

wer in your pick-up system. Humming and sizzling

can be caused by an empty battery.

5. Functional characteristics

5.1 Tone control

master

treble

line out

pre out

The two-band equalizer of your AG 8

with an active and high quality sound interaction

tool that supports the natural tone of instruments

and voice whilst simultaneously offering you the

possibility of a controlled accentuation

If bass and treble are set to the center position, the

tone controls are neutral and have no influence on

the sound.

Push

bass

mic

aux

mic in

XLR = P48

provides you

Made in Germany

may

line

aux in

power