Acoms Technisport 2.4G Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Telecomando Acoms Technisport 2.4G. Acoms Technisport 2.4G 14.

Stampa la pagina

1. Function Setting

Cruton to install tho rccolyer

. When you inslallthe receiver in a low postion In a brg scale model. f the antenna wire is not

coming up high enough or antenna wrTe rs surrounded by metal componenls sllch as metal

roll bar, the electricalwave may be ntercepted. In ths case, we recommend to change the

receiver position lo the front side of the car of upp€. sile ot the mechanical plale

. To avoid direcl vbraton dunng drivrng. recerver should be fued rn a pace whch wrllnol louch orner

parts using thick double srded lape n case ol Engne Ca, receiver should be wrapped In sponge etc

To avoid strong vibration, olherwise I rnay cuase rnallunction due to shock or vrbratron.

. The receiver and antenna shou d not be cbse to rnoto.. sp€ed conlroller, NFcd batlery or

silicon cord as thoy cause interference dt€ to a lot ot electrical noise.

. Operate each seNo and check that unnGsay

saing is not experienced on the push roo,

otherwise il could cause servo darnage or $gtg| banery ffe.

. Servo should be fxed w lh rubber gro.rrrEis h a plac€ which will nol louch wrth other parts

to avoid dired vibration to the servo. o0Erih€ s€rvo rnay be damag€d by shock or vibration.

. When used in an Engine Car be careld tlydl fuel or exluust gases are not put on lhe receNer

Cartlon to lnstan tJr

antrnre

. Never cul, lengthen or bnd lh€ trEna wre as lhe

wavelength ior 2 lGHz rs shql td it b v€ry sensitive to the

length ol antefna {/rre

. Anlenna p pe should be A.a ittrt€nna

holder on the

receiver to keep tlE flUn

u,l9 aa/ay from metal or

caroon malerral.

In case lhe anldna ho*d€. b irslalled olrlside, t should be

as c ose to lhe l€@rv€( as posstble. lf lhe antenna wire lrorn

recever io hold€r ts longer, thdr sensilivrly becornes less.

. When yoLr pul lhe anlenna holder on the metal parts or

carbon chasss, do nol put the antenna wire directly on the

metal or carbon.

. Antenna iead should be put into antenna pipe for

proleclon.

Please use pasl c anlenna prpe so thal anlenna wre can

keep slrarghl.

. Do not put lhe antenna wrre near eleclic conduclors such

as metal or carbon, rl causes less sensibility due to

inlerf€fenco.

Especially, such as right rluslratDn, antenna wire shou d

be rnstalled more lhan 3ornrn away irom the electrc

conoucIot

Also nole that the middle part of th6 antenna w re shoutd

nol be cose to lhe melalor carbon.

3 r

; l

-t-

r ' , . ! l r r ; t j