Acon AirTrack 3m 10ft Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Sport e attività all'aperto Acon AirTrack 3m 10ft. Acon AirTrack 3m 10ft 3.

HAND PUMP USER INSTRUCTIONS

Inflating the AirTrack: Remove the AirTrack from the carrying case and roll out fully so that

the valves are visible. Depending on the model, the AirTrack can have one or two valves; if

there are two valves, you can use either to inflate or deflate the AirTrack. Only use the pump

that is included with the AirTrack.

Open valve cover (1). Ensure that the valve button is in the up-position (2). Place the

head of the pump tube into the valve and twist to the right so that the pump and valve

connect tightly (3).

Recommended pressure for AirTrack is 5-6 PSI. The bounciness of the AirTracks

depends on how much pressure you put in it. Our recommended pressure level is 5-6

PSI but the most optimal pressure depends on the users' preferences. Pump until the

desired air pressure level is seen on the pump's air pressure meter. Remove the head

of the pump tube by twisting to the left. Put the valve cover back in place. Ensure

that the valve cover is properly in place to avoid air leaking from the AirTrack.

Deflating the AirTrack: Push the valve button into the down-position and the valve will open (2).

If air leaks around the valve, follow these steps:

Remove the valve key from its packing case.

2. Open the valve cover and place the valve key in the valve.

3. Turn the valve key clockwise until there is no space

between the valve and the AirTrack. Do not turn

the key counterclockwise as this will cause the valve

to loosen, leak air, and eventually detach from

the AirTrack.

4. Close the vent and check to see if the leak stopped.