AlcoMate premium AL-7000 Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di prova AlcoMate premium AL-7000. AlcoMate premium AL-7000 4. +/-0.01% up to 0.10% bac accuracy
Anche per AlcoMate premium AL-7000: Manuale d'uso (4 pagine), Manuale dell'operatore (9 pagine)

Stampa la pagina

Sensor Module Replacement

Please take the following steps to install a new

sensor module.

(VERY IMPORTANT: The

device MUST BE TURNED OFF in order to

avoid IMMEDIATE DAMAGE to the sensor.)

Remove the module by

pulling it straight

back.

Warnings

WAIT AT LEAST 20 MINUTES AFTER EATING OR DRINKING BEFORE TESTING. A

breathalyzer examines "lung air" samples, not "mouth air" to calculate alcohol content. Any

"contaminants" in the mouth, including alcohol, food, smoke, or even excess saliva, may

interfere with testing. This includes alcohol-based mouthwash or similar products. This is the

most common cause of improper use and incorrect results.

Avoid testing in high wind or enclosed spaces. Poor ventilation may also lengthen the time

required for warm up between tests.

Do not blow smoke, saliva or other contaminants into the mouthpiece, as the sensor may

become damaged.

Do NOT use the Premium as a tool to drink and drive.

Keep out of extreme temperatures and out of the reach of children.

To maintain accuracy, the sensor module inside the Premium must be replaced every 200 tests

or at least once yearly (whichever comes first). Large numbers of "high positive" (high

alcohol) readings may require replacing the module much sooner than normally expected.

WARNING DISPLAY "Flow": If you see "Flow" in the display, the breath sample was not

strong or long enough for measurement. As soon as you start blowing into the device, you

will hear a long beep indicating how long you should blow.

WARNING DISPLAY "Cal": If you see "Cal" in the display, the Premium needs a new sensor

module. If the cumulative test counter reaches 300 tests, the Premium will display Cal

automatically. Please purchase and install a new sensor module.

WARNING DISPLAY "Bat": If you see "Bat" in the display, the battery power is low. Please

replace the batteries.

Insert a new sensor

module in the

original position.

Open the easy-

replace sensor panel.

Make sure the new

sensor module is

firmly secured.

You will see the

sensor module.

Close the easy-

replace sensor panel.

Ready for testing!