3Com H3C S3100 16C SI Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Hardware di rete 3Com H3C S3100 16C SI. 3Com H3C S3100 16C SI 11. Loopback detection feature manual

H3C Loopback Detection Feature Manual

Release 2107

2.1.3 loopback-detection interface-list enable

Syntax

loopback-detection interface-list enable

undo loopback-detection interface-list enable

View

System view

Parameter

interface-list: Ethernet port list, in the form of interface-list = { interface-type

interface-number [ to interface-type interface-number ] } &<1-10>, where

interface-type is the port type, and interface-number is the port number.

Keyword to is used to specify a range of ports. The port number after to must be

equal to or greater than that before to.

&<1-10> means that you can specify up to 10 ports or port ranges.

Description

Use the loopback-detection interface-list enable command to enable the loopback

detection function on a range of ports.

Use the undo loopback-detection interface-list enable command to disable the

loopback detection function on a range of ports.

By default, the loopback detection function is enabled on ports if the device boots with

the default configuration file (config.def); if the device boots with null configuration, this

function is disabled.

At present, you can configure the loopback detection for ports in bulk on the S3100-EI

series (except the S3100-EPON-EI series) switches and the E126A switch only. These

switches are all shipped with a default configuration file (config.def).

Example

# Enable the loopback detection function on ports Ethernet 1/0/1 through Ethernet

1/0/4.

<H3C> system-view

System View: return to User View with Ctrl+Z.

[H3C] loopback-detection enable

[H3C] loopback-detection Ethernet 1/0/1 to Ethernet 1/0/4 enable

Chapter 2 Loopback Detection Configuration

2-4

Commands