3Com IntelliJack NJ200 Manuale supplementare - Pagina 5
Sfoglia online o scarica il pdf Manuale supplementare per Hardware di rete 3Com IntelliJack NJ200. 3Com IntelliJack NJ200 14. Network jacks
Anche per 3Com IntelliJack NJ200: Manuale del software (7 pagine), Scheda tecnica (4 pagine)
Stampa la pagina
3 C O M
®
N J 2 0 0 N E T W O R K J A C K — V L A N S & T R A F F I C P R I O R I T I Z AT I O N
Figure 3. Ingress and egress modes can be viewed
and configured using 3Com Central Configuration
Manager.
2. Click on the
Hardware Settings
egress modes. You should see a window like this:
3. Use the pull-down menu to set the desired
a) Frames transmitted unmodified
b) Add 802.1 tag to untagged frame
4. Use the pull-down menu to set the desired
a) Frames received unmodified
b) Remove 802.1 tag if present
Apply
5. Click on
to proceed to the password-request window. Once a password is
entered and accepted, the next window will show a summary of the new settings.
OK
6. Click
to finalize and exit the configuration window.
Setting the PAN Port Associations
The PAN (device) ports can support up to four different VLAN domains. 3Com Central
Configuration Manager lets you assign individual ports to four separate VLANs, all
ports to the same VLAN, or any combination in between. The following example illus-
trates how the Port Associations are used to create two port groups assigned to separate
VLANs—where the ports in one group cannot share traffic with ports in the other.
3Com Central Configuration Manager
1. Open
2. From the list of devices, select an NJ200 Network Jack and then select
Configuration
. You can also highlight and right-click on the switch and select
Configuration
.
tab to view the LAN (uplink) port ingress and
LAN Egress Mode
, either:
LAN Ingress Mode
, either:
Devices
and select
from the main menu.
5