Xerox 4250 - WorkCentre - Copier Manuale d'uso rapido - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso rapido per Stampante Xerox 4250 - WorkCentre - Copier. Xerox 4250 - WorkCentre - Copier 42. A4 black and white multifunction system
Anche per Xerox 4250 - WorkCentre - Copier: Caratteristiche (1 pagine), Specifiche tecniche (8 pagine), Manuale del valutatore (16 pagine), Manuale supplementare (1 pagine), Opuscolo e specifiche (4 pagine), Manuale del valutatore (16 pagine), Specifiche tecniche (4 pagine), Installazione e funzionamento sicuri (4 pagine), Manuale di servizio (13 pagine)

Stampa la pagina
Xerox 4250 - WorkCentre - Copier Manuale d'uso rapido

Connecting to the Network

Follow these instructions to connect the machine to an Ethernet TCP/IP network.
If you are connecting your machine to a different type of network, or you wish to use
other protocols, refer to the System Administration CD.
Test the device
Before connecting the machine to your network, make sure that it is operating
correctly as a copier.
1
Place a document in the Document Feeder and make 3 copies.
2
If the copies are made successfully, install the network connection as described in
the next steps. If copying is not successful, refer to Troubleshooting on page 33.
Network Connection using TCP/IP
You can set up the TCP/IP network connection using either of the following methods:
•
DHCP: Use this method to allow a DHCP server to automatically assign an
IP address. This is the factory default setting.
•
Static IP address: Use this method to manually assign an IP address
provided by the network administrator.
When the machine is powered on, it automatically uses DHCP to obtain its network
configuration. To use a static IP address, DHCP must be turned off and the IP address,
gateway address, subnet mask, and DNS Server address must be entered manually.
1
Connect the Ethernet cable to the RJ45
connector on the back of the machine.
NOTE:
The Ethernet cable is not supplied
by Xerox.
2
To setup the address using DHCP, see
Network Setup Using DHCP on page 10. If
you want to set a static IP address, skip to
Network Setup Using a Static IP Address
on page 11.
Network Setup Using DHCP
1
After the machine starts, it negotiates with the DHCP server for an IP address. Wait
two minutes for the network setup to complete and then check the allocated IP
address as follows:
•
On the Control Panel, press the Log In/Out button and then enter the
Administrator's Password [1111] and select Enter.
10
RJ45
Network
Connector
quick use guide