Xerox 6100BD - Phaser Color Laser Printer Manuale introduttivo - Pagina 32

Sfoglia online o scarica il pdf Manuale introduttivo per Stampante Xerox 6100BD - Phaser Color Laser Printer. Xerox 6100BD - Phaser Color Laser Printer 34. Disk overwrite installation and usage
Anche per Xerox 6100BD - Phaser Color Laser Printer: Manuale di installazione (34 pagine), Specifiche tecniche (2 pagine), Manuale d'uso (32 pagine), Opuscolo e specifiche (4 pagine), Manuale d'uso (28 pagine), Manuale di installazione (2 pagine), Manuale di sicurezza (38 pagine), Manuale di installazione (2 pagine), Nota di rilascio (2 pagine), Manuale introduttivo (37 pagine), Manuale (34 pagine), Manuale (34 pagine), Manuale d'uso (32 pagine), Manuale (11 pagine), Manuale di installazione e funzionamento (8 pagine)

Performing a recovery

Performing a recovery may require one or two steps:

♦ If the system disk had to be replaced, a flash (clean) install of

Solaris must first be performed. This partitions the system disk

and takes approximately 20-25 minutes. A Solaris install must

be performed by the Xerox service representative. As soon as

the system starts rebooting, halt to the system at the ok

prompt by pressing [Stop][A].

♦ Launch the recovery program by following the steps below.

The system must be booted to single-user mode from

CDROM. If the TGBackup scripts are on CD, the CD must

be bootable to perform the recovery.

Ensure that the tape drive is connected, powered on and

that the tape cassette #1 is inserted in the drive. If multiple

tape drives are attached to the system, make sure the

others are offline or have no tapes in them. The program

attempts to use the first ready tape drive it finds.

Insert a bootable CD/DVD (Solaris flash install CD or

bootable TGBackup CD).

Power the system on. When the message boot device file

and args appears, press [Stop][A] to bring the system to

the ok prompt.

NOTE: For some controllers, it may be necessary to

substitute cdromide for cdrom in the next step. Refer to

your documentation for the correct terminology for your

specific controller.

Enter the command boot cdrom -s to boot into single-

user mode. The system may take up to 5 minutes to

display the # prompt.

Enter the command /etc/init.d/volmgt start to start the

volume manager.

Enter the command cd /cdrom/cdrom0/TGBackup to

change the directory to the location of the recovery files.

Enter the command sh start_tgrestore to launch the

recovery. The program searches for a tape drive and

begin the recovery process.

NOTE: If the backup spanned multiple cassettes, the

system prompts the user to insert the next volume when all

the data is read from the current tape.

Upon completion the program reboots the printer.