Xerox 850DP - Phaser Color Solid Ink Printer Nota di rilascio - Pagina 19

Sfoglia online o scarica il pdf Nota di rilascio per Stampante Xerox 850DP - Phaser Color Solid Ink Printer. Xerox 850DP - Phaser Color Solid Ink Printer 33. Installation guide for accxes 10.2
Anche per Xerox 850DP - Phaser Color Solid Ink Printer: Specifiche tecniche (2 pagine), Manuale dell'operatore (16 pagine), Manuale supplementare (1 pagine), Manuale supplementare (11 pagine), Manuale di configurazione (1 pagine), Manuale di istruzioni per la pulizia (9 pagine), Manuale di aggiornamento (8 pagine), Manuale supplementare (26 pagine), Nota di rilascio (11 pagine), Nota di rilascio (11 pagine), Istruzioni per l'installazione (2 pagine)

8.1.2 Firmware Installation of a Device Failed

If a firmware installation fails, repeat the installation procedure. Occasionally, other events may

interrupt the firmware installation on the AccXES controller.

If, after a firmware installation, the system begins to print out blank pages the hardware needs to

be reset. Simply power down the controller and disconnect it from the printer. After waiting a

short time (30 seconds to 5 minutes) reconnect and reboot the controller, it should resume

normal operation.

If the user tries to upload a stamp files that contains an invalid format, or if the Accounting Mode

is set to "Enabled", no error message will be displayed. The WebPMT screen will display a

message that the file was uploaded successfully and the stamp's filename will not appear in the

"Printer Resident Stamps" list.

To avoid this situation, set the Job Accounting mode to "Optional" before uploading stamps. The

WebPMT has no knowledge of the validity of any file that is sent to the printer. File validation and

error handling is done on the printer by the AccXES controller. The WebPMT only reports that the

file was sent to the printer successfully.

The media size "ANY" will select the best sheet size for an image to prevent clipping. If a user

specifies a media size of "ANY" and a scale factor that makes the image too large for any sheet

size and mismatch mode is set to scale, the controller will select the largest sheet size and scale

the image to fit on it.

If this is not the desired behavior, a specific sheet size can be selected, or the media mismatch

mode can be set to QUERY.

If the margins (TOP, BOTTOM, RIGHT and LEFT) are set to a non-zero value (5mm is the

default) then that amount of whitespace will be added to the image before placing it on the media

and could cause part of the image to be shifted off the page, or clipped. To correct this problem

set the margins to 0.

Certain CGM files contain rotation commands which can confuse the system when folding. If the

titleblock is not visible or the plot is bypassed and not folded, change the titleblock location to

obtain a correctly folded document.

Intermittant image wraps have been seen when very LARGE jobs (>256 Pages) are submitted to

the 721 printer. The best work around is to set the job to forward collation so all the pages are

rendered prior to printing.

Page 19