Xerox DOCUCOLOR 12 Utilizzo del manuale - Pagina 10

Sfoglia online o scarica il pdf Utilizzo del manuale per Accessori per stampanti Xerox DOCUCOLOR 12. Xerox DOCUCOLOR 12 12. Carrier
Anche per Xerox DOCUCOLOR 12: Specifiche tecniche (2 pagine), Manuale di riferimento (10 pagine), Manuale di avvio rapido (5 pagine), Manuale di avvio rapido (8 pagine), Manuale supplementare (4 pagine), Manuale integrativo (18 pagine), Manuale introduttivo (24 pagine)

O REASSEMBLE THE

Power switch

Power connector

Mouse

Keyboard

Monitor

Copier interface (scan)

Copier interface (print)

(not used)

10/100BaseT

Using the Fiery X12/Fiery X40 Advanced Controller Interface Kit

X12/F

IERY

1. Reseat all boards, cables, connectors, and other parts loosened or removed during

inspection or service.

2. Place the Fiery X12/Fiery X40 in its standard operating position.

3. Place the side panel onto the Fiery X12/Fiery X40 so the grooves on the bottom of the

side panel ﬁt into the grooves in the tray.

Be careful not to damage any ribbon cables; if necessary, fold the ribbon cables inside the

tray before replacing the side panel.

4. Close the side panel. Two clips on the top edge of the panel will click when it is properly

installed.

5. Replace the screw that secures the side panel.

Do not leave the Fiery X12/Fiery X40 side panel off after servicing. An airﬂow

OTE

channel is created by the side panel and the fan. Leaving the Fiery X12/Fiery X40 open

could reduce the operational life expectancy of internal Fiery X12/Fiery X40

components.

6. Connect any cables removed during service to the back of the Fiery X12/Fiery X40.

7. Connect the monitor, keyboard, and mouse to the back of the Fiery X12/Fiery X40.

8. Connect the monitor power cable to the back of the monitor (some monitors may already

have this cable attached).

X40