Xerox Synergix 8855 Manuale supplementare - Pagina 5

Sfoglia online o scarica il pdf Manuale supplementare per Accessori per stampanti Xerox Synergix 8855. Xerox Synergix 8855 28. Windows nt 4.0 postscript print driver user guide
Anche per Xerox Synergix 8855: Manuale d'uso (44 pagine), Manuale dell'operatore (11 pagine), Manuale supplementare (26 pagine), Manuale del software (30 pagine)

Xerox Synergix 8855 Manuale supplementare
EMC Notices (continued)

Japan

This is a Class A product based on the standard of the Voluntary Control
Council for Interference by Information Technology Equipment (VCCI). If this
equipment is used in a domestic environment, radio disturbance may arise.
When such trouble occurs, the user may be required to take corrective
actions.
Changes or modifications to this equipment not specifically approved by Fuji
Xerox Limited may void the user's authority to operate this equipment.
Shielded cables must be used with this equipment to maintain compliance
with the Voluntary Control Council for Interference by Information Technology
Equipment regulations.

USA

This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Changes or modifications to this equipment not specifically approved by the
Xerox Corporation may void the user's authority to operate this equipment.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
XES Synergix 8855 Controller Setup Manual for Firmware 7.0
iii