Direct Supply Direct Choice Istruzioni per il montaggio - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Aiuto alla mobilità Direct Supply Direct Choice. Direct Supply Direct Choice 2. Three-in-one commode

Stampa la pagina
Back
Support
Seat
Frame
Tip
Commode
WEIGHT CAPACITY : 300 LBS
Assembly Instructions
SET-UP
1.
Remove frame, seat, lid, pail, cover and splash shield
from carton. Allow toilet seat and lid to reach room
temperature if exposed to cold. This will help prevent
the seat and lid clamps from cracking while being
assembled onto commode back frame rail.
2.
Align the toilet seat clamps onto the back frame rail
(both clamps should sit outside the pale brackets).
Push down on seat until clamps snap firmly into place.
3.
Repeat the same process for the lid.
4.
Install bucket by placing splash guard and bucket
between frames. Reverse to remove.
ADJUST COMMODE HEIGHT
1.
Depress the height adjustment button and slide
the lower leg upward or downward until the height
adjustment button is fully engaged in the desired hole.
2.
Repeat for other three legs.
CAUTION: Ensure that all four commode legs
are adjusted to the same height, and that all
height adjustment buttons protrude fully through
adjustment holes before use.
REMOVE BACK SUPPORT
1.
If it is desired to remove the back support, simply
unscrew the wing nut assembly on each side.
USE COMMODE OVER TOILET
1.
Set commode to desired height (see adjusting
commode height).
2.
Position splash shield in place onto pail supports.
3.
Remove
back
support
support section).
4.
Lift toilet bowl seat and place commode over toilet
with splash shield positioned over the center of toilet
bowl. Commode is now ready for use. Clean seat and
splash shield with disinfectant after each use.
Lid
Back Frame
Rail
Height
Adjustment
Holes
Pail
(see
removing
USE AS A BEDSIDE COMMODE
1.
Set commode to desired height (see adjusting
commode height).
2.
Push commode pail onto pail supports. Ensure that
pail is properly positioned below commode opening.
Commode is now ready to use.
3.
When user is finished using commode, place commode
pail lid over commode pail to contain odors.
4.
Remove pail and lid simultaneously to empty pail.
Clean seat and pail with disinfectant after each use.
MAINTENANCE
1.
Use a mild soap and water solution, rinse with
clear water, then dry with a soft cloth. Ensure that
commode is well rinsed before using.
2.
Never use organic solvents, abrasive cleaners or
scouring pads on any part of commode.
3.
Check fit and tightness of all nuts, bolts and knobs
weekly to ensure that the commode is safe to use.
DO NOT ATTEMPT TO ADJUST OR OPERATE COMMODE
WITHOUT READING ALL INSTRUCTIONS CAREFULLY.
•
This product should not be used without instruction
from a healthcare professional.
•
Toilet seat must be in down position before use.
Failure to do so may result in injury.
•
Make sure that the height adjusting snap buttons fully
protrude through the same respective hole of each
leg extension. This will ensure the leg extensions are
locked in position and an even height is achieved.
•
All four leg extensions with rubber tips must touch
the floor at all times.
•
Users with limited physical strength should be
supervised or assisted while using commode.
•
Direct Choice assumes no responsibility for any
damage or injury caused by improper installation,
assembly or use of this product.
Our promise to you is that you will have a convenient
and easy ordering experience, receive a quality Three-In-
back
One Commode, and enjoy outrageous customer service.
If you have any questions about the commode you have
purchased or would like to request warranty service, please
contact: Direct Supply
1-800-634-7328, 6767 North Industrial Road, Milwaukee,
Safety Precautions
Customer Service
Equipment & Furnishings
®
at
™