Econox CarboProbe CP Plus Manuale di istruzioni per l'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Apparecchiature di prova Econox CarboProbe CP Plus. Econox CarboProbe CP Plus 7.

Introduction

The CP probe is a very simple, low cost oxygen probe with an easy-to-read digital meter

displaying oxidation/reduction. The CP Probe saves you money by omitting the

thermocouple pyrometer, so that you can continue to use cones. This probe is ideal to

control both gas and wood-fired kilns.

An oxygen probe works by comparing the oxygen level in the kiln with the oxygen level

inside the alumina tube. This is why the air inside the tube must always be renewed. If the

temperature of the zirconia tip is over about 700 °C, it produces an electrical voltage. The

less oxygen in the kiln, the bigger the electrical voltage, so the voltage can be used as a

guide to the oxygen level.

ECONOX supplies 2 different kinds of CP probes

The advantages of measurement of oxidation/reduction include:



Fuel savings - an economical firing depends on supplying the right ratio air/fuel,

without waste of energy from heating excess air.



Reliable glaze colors - Knowing the right level of reduction every firing gives

you the colors you want, firing after firing.



Reduced air pollution - Use the CP Probe as a guide for stoking wood-fired kilns

to reduce wood consumption and unnecessary ash and smoke.

X:\Fiches tech. - Normalisation\ECONOX\Normalisation\Mode d'emploi\PDF\sonde

For the measure of oxygen concentration only

For measure of oxygen concentration AND temperature

(includes an R-type thermocouple for temperature up

to 1700°C)

4/7