eControls RT2 Manuale dell'utente e dell'installatore - Pagina 5
Sfoglia online o scarica il pdf Manuale dell'utente e dell'installatore per Controllore eControls RT2. eControls RT2 8. Wireless whf control
Anche per eControls RT2: Manuale del proprietario e dell'installatore (12 pagine)
Stampa la paginaINSTALLATION
Homes with plaster walls with steel lathe may
experience wireless communication interference
when using wireless controls.
!
CAUTIONS
Turn off power before installing whole house fan or
WHF controls.
Read and follow all instructions carefully, including
those included with the whole house fan.
Read entire manual before installing products.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical
codes.
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
When servicing WHF Controls or accessing products,
turn off all power to these items.
WIRING FC2J TO WHF
!
Warning!
Turn the power to the HVAC equipment off before wiring.
FC2J Outside
FC2J Inside
INSTALLER SECTION
1)
2)
3)
4)
5)
6)
Wiring FC2J to 1-Speed WHF
For 1 speed WHFs, the PWM, COM and Low Speed
wires should be cut off at the PCB.
High Speed
Low Speed
PWM COM
PWM
120VAC
Neutral
Ground
High Speed (Purple)
Neutral (White)
Ground (Green)
120VAC (Black)
5
ATTENTION INSTALLER
Wire FC2J control board to WHF. Install control board
in single gang electrical box located on WHF.
Connect the FC2J control board to the RM2 radio
module using Plug&Play cable provided.
Install optional Damper Control.
Install optional Outdoor Temperature Sensor.
Set Zone and Home number if necessary.
Select type of WHF..
FC2J Wire
Connects
WHF High Speed (Black)
WHF Neutral (White) and
120VAC Neutral (White)
WHF Ground (Green) and
Power Ground (Green)
Power 120VAC (Black)
Electrical box on WHF
Power
Cord