Yamaha AvantGard N2 Manuale di manutenzione - Pagina 22

Sfoglia online o scarica il pdf Manuale di manutenzione per Strumento musicale Yamaha AvantGard N2. Yamaha AvantGard N2 45. Hybrid piano

6. Front Rail

Remove the nine key bed bottom screws [280] and the four key bed upper screws [290A], and remove the key slip.

[280]

7. Key Stop Rail

A key nonwoven fabric (black) is attached to the key stop rail so take care not to tear it during removal.

* There are 10 setscrews on the center rail top panel above the nonwoven fabric (black).

8. Action

8-1

Remove the hammer sensor connector.

8-2

Remove the action.

Remove the action bracket installation screws and remove the action while gripping the

lower sound part of the shank stopper and the next high sound part of the shank rail as

shown in the photo (right).

* We recommend you use a screwdriver with long shaft to remove the screws

for the action bracket.

9. Shank Stopper

Remove a total of 6 screws at the four locations in the photos, and remove the shank stopper.

10. Hammer Sensor Unit

Removal of the hammer sensor unit is the same as for the GP-SG Silent.

Key bed bottom

[280]

[290A]

SHANK STOPPER