Yamaha Disklavier DGP1 Manuale di manutenzione - Pagina 22

Sfoglia online o scarica il pdf Manuale di manutenzione per Strumento musicale Yamaha Disklavier DGP1. Yamaha Disklavier DGP1 50.

MAINTENANCE

As with previous hybrid models, the technician ﬁrst adjusts the acoustic system, then adjusts the silent

system (except for model DGA1, which does not have a silent system), and then lastly adjusts the elec-

trical system using the built-in maintenance and test modes.

Important

Be sure to turn off the main power switch before removing the action or carrying out any other type of

assembly.

To remove the action (when necessary to perform action regulation or voicing), proceed as follows. Be

careful to keep action clear of treble-side cables and cable connectors.

(1) Set the piano into Acoustic mode.

(2) Switch off the controller power and the main switch (on the Ampliﬁer unit.)

(3) Remove the controller (under the key bed).

(4) Remove the fallboard, key block, and key slip.

(5) Remove the cable connector from the side-arm on the treble side.

(6) Pull out the action.

(7) If necessary, remove the hammer sensor (models C3 to C7).

The screws on the shank-rail side of the hammer sensor secures both the regulating rod and the sensor.

This means that you must remove the regulating rod ﬁrst, then remove the sensor, then reattach the rod

and carry out adjustment as necessary. If you need to completely remove the regulating rod, you can do

so by ﬁrst removing the action from the keyboard (to create a gap between the jack and the regulating

button), and then removing the two screws at the treble-side bracket so that the rod comes free.

The DKV MKIII series includes a motor-driven silent mechanism. The user selects acoustic or silent

mode by setting the switch in the switch-box (located on the lower left side of the keybed). If silent

mode is selected, the switch-box LED will light up and the motor on the MD unit (mounted on the right

rear of the key bed) will move the shank stopper and regulating rod into place.

Adjusting the Action Regulation

Check that LET-OFF adjustment is approx. 2mm.

Check that drop adjustment is approx. 2mm.