Yamaha SILENT Bass SLB300 Manuale d'uso - Pagina 18

Sfoglia online o scarica il pdf Manuale d'uso per Strumento musicale Yamaha SILENT Bass SLB300. Yamaha SILENT Bass SLB300 23.
Anche per Yamaha SILENT Bass SLB300: Manuale d'uso (24 pagine)

Yamaha SILENT Bass SLB300 Manuale d'uso
 Turning the Power On and Off
With a plug (cable) inserted into the LINE OUT jack of this product, push
the [POWER] switch up to turn the power on, and down to turn the power
off. When the power turns on, the status display LED will flash (page 10).
NOTE
• To prevent the battery from being depleted, be sure to turn the power switch off after finish-
ing use. Also, remove the cable.
• You can use this product even without batteries by turning the power switch off (to passive
output) and connecting the product to an external device that supports passive output.
When using an external device, connect a device (DI, etc.) that has input impedance of 10
MΩ or higher. Sufficient output and frequency characteristics may not be ensured if the
input impedance of the connected device is lower than the specified value.
NOTICE
• To prevent faults in this product or the external device as well as noise, be careful regarding the
order in which you turn the power switch on or off and make connections.
Order for Turning the Power Switch Off and Making Connections (Example)
1.
Lower the level of the channel to which this product is connected on the output device, such as a PA.
2.
Turn off the power switch of this product.
3.
Disconnect this product and the output device, such as a PA.
4.
Connect this product and a DI or the like already connected to a PA or the like.
5.
Check that the level of the channel to which a DI or the like is connected on the output device such as
a PA is lowered.
6.
Turn on the switch of the DI or the like.
7.
Raise the level of the channel to which a DI or the like is connected on the output device such as a PA.
 About the Mute
Since the SILENT Bass
the system can sometimes pick up string vibrations that occur between the bridge and
tailpiece. If this sound is bothersome or unwanted, you can mute it by attaching the sup-
plied mute onto the strings as shown in the illustration below.
* The effectiveness of the mute will be reduced if it is attached midway between the
bridge and the tailpiece.
TM
is designed with a pickup system that picks up string vibration,
* Midway between
the bridge and the
tailpiece
Mute
Mute
* Midway between the
bridge and the tailpiece
SLB300 Owner's Manual
18