Yamaha WX5 Manuale d'uso - Pagina 22
Sfoglia online o scarica il pdf Manuale d'uso per Strumento musicale Yamaha WX5. Yamaha WX5 44. Yamaha wind midi controller owner's manual
Stampa la pagina
Setup Switch Settings
The WX5 has 16 DIP switches which can be used to set up
a range of important basic parameters. These switches are
not intended for frequent use, but rather to set up the WX5
to match your individual playing requirements. Read the
descriptions below carefully before changing the setup
switch settings.
Remove the rubber switch cover, and use a small screwdriver or similar imple-
ment to change the switch settings as required.
The switches are OFF when flipped to the left, and ON when flipped to the
right. All switches are OFF when the WX5 is initially shipped.
Switch 1-1 (Vel) - Velocity
Determines whether the key-on velocity will be fixed or
controlled by wind pressure.
SW 1-1
Setting
OFF
Variable (fixed time delay)
ON
Fixed (velocity - 100)
Switch 1-2 & 3 (Win) - Wind Sensor to MIDI Data
Specifies the type of MIDI data via which the WX5 wind
data will be transmitted.
SW 1-2
SW 1-3
OFF
–
ON
OFF
ON
ON
• When using the WX5 with a tone generator which does
not have a WX IN connector, be sure to set the SW1-
1(Vel) switch ON so that a fixed velocity value is transmit-
ted, and set the SW1-2(Win) and SW1-3(Win) switches
so that MIDI expression control (SW1-2 ON, SW1-3 OFF)
or volume control (SW1-2 ON, SW1-3 ON) is transmitted.
Switch 1-4 (Win) - Wind Curve
Determines the relationship between breath pressure and
the output MIDI volume data.
SW 1-4
Setting
OFF
Normal
ON
Hard (requires considerable breath pressure to
produce maximum volume)
Switch 1-5 (Lip) - Tight Lip/Loose Lip Mode
Selects the Tight Lip or Loose Lip playing mode. In the
Tight Lip mode pitch can be bent up and down via lip
pressure, but in the Loose Lip mode pitch can only be
bent upward via lip pressure (page 11).
SW 1-5
Setting
OFF
Tight Lip
ON
Loose Lip
22
Setting
Breath Controller
(control change #2)
Expression (control change #11)
Volume (control change #7)
1-1
Vel
1-2
Win
1-3
1-4
Win
1-5
LIP
1-6
LIP
1-7
LIP
1-8
LIP+
nrm
B/C EXP
VOL
nrm hrd
tht
loos
nrm wide
P/B M/W
off
Switch 1-6 (Lip) - Lip Data Range
Determines the range of data which can be produced via
lip control, depending also on the setting of Switch 1-7
(Lip Data), below.
SW 1-6
Setting
OFF
Normal
ON
Wide (greater range)
When Lip Data is set to "Pitch Bend"
Tight Lip Mode
Normal
Reed Open
-16
Center
0
Maximum
+32
Loose Lip Mode
Normal
Reed Open
0
Maximum
+32
When Lip Data is set to "Modulation Wheel"
Tight Lip Mode
Normal
Reed Open
48
Center
64
Maximum
96
Loose Lip Mode
Normal
Reed Open
0
Maximum
64
2-1
Trns
2-2
2-3
Fing
2-4
Fast
2-5
2-6
Hi ct
2-7
Whl
2-8
fix
A
C
B
Fl
off
on
off
on
PB
gen
on
MW
filt
Wide
-64
0
+63
Wide
0
+63
Wide
0
64
127
Wide
0
127