Yamaha HTR-5064 Manuale di configurazione facile - Pagina 3

Sfoglia online o scarica il pdf Manuale di configurazione facile per Ricevitore Yamaha HTR-5064. Yamaha HTR-5064 8. Setup guide

Stampa la pagina

Connecting speakers

• (U.S.A. and Canada models only) The unit is configured to

8Ω speakers as the factory setting. 6Ω speakers can be also

connected.

• (Except for U.S.A. and Canada models) Use the speakers

with an impedance of at least 6Ω.

• Use a subwoofer with a built-in amplifier.

• Disconnect the power plug before connecting the speakers.

• Be careful that the core of the speaker cable does not touch

anything or come into contact with the metal areas of the unit.

If this happens, it may damage the unit or the speakers. If the

speaker cables short circuit, "CHECK SP WIRES!" will appear

on the front panel display when the unit is switched on.

Connecting speaker cables

Speaker cables have two wires. One is for connecting the

negative (-) terminal of the unit and the speaker, and the

other is for the positive (+) terminal. If the wires are color-

coded to prevent confusion, you should connect the black

side to the negative terminal and the other wire to the

positive terminal.

1 Remove approximately

10 mm (0.4 in.) of insulation

+ (Red)

from the end of the speaker

cable and twist the bare wire

firmly.

2 Loosen the speaker terminal.

- (Black)

3 Insert the bare wire into the

gap on the side of the terminal.

When it is difficult to insert the wire into the gap on the

side, insert it into the gap downside of terminal.

4 Tighten the terminal.

Connecting banana plugs

(Except U.K., Europe, Asia and Korea models)

Tighten the knob, and then

insert the banana plug into the

Banana plug

end of the terminal.

Connect the front speakers (

the FRONT (

The unit (rear)

FRONT

F R

O N

F R

O N

) to

) terminals.

SURROUND BACK/

BI-AMP

CENTER

SURROUND

SINGLE

SUBWOOFER

SPEAKERS

Connect the center speaker (

CENTER terminal.