Yamaha HTR-5230RDS Manuale d'uso - Pagina 18

Sfoglia online o scarica il pdf Manuale d'uso per Ricevitore Yamaha HTR-5230RDS. Yamaha HTR-5230RDS 50. Natural sound av receiver

Stampa la pagina
CONNECTIONS

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON is pressed, the IMPEDANCE SELECTOR switch may not be fully slide
to either position. If so, slide the switch to either position fully when this unit is in the standby mode.
Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.
IMPEDANCE
SELECTOR
SET BEFORE POWER ON
MAIN A OR B : 4 MIN. /SPEAKER
A + B : 8 MIN. /SPEAKER
CENTER
: 6 MIN. /SPEAKER
REAR
: 6 MIN. /SPEAKER
MAIN A OR B : 8 MIN. /SPEAKER
A + B : I6 MIN. /SPEAKER
CENTER
: 8 MIN. /SPEAKER
REAR
: 8 MIN. /SPEAKER

Connecting the Power Supply Cords

AC OUTLETS (SWITCHED)
(Europe model)
MAINS
SET BEFORE POWER ON
100W MAX. TOTAL
SWITCHED
MAIN A OR B : 4 MIN. /SPEAKER
A + B : 8 MIN. /SPEAKER
CENTER
: 6 MIN. /SPEAKER
REAR
: 6 MIN. /SPEAKER
MAIN A OR B : 8 MIN. /SPEAKER
A + B : I6 MIN. /SPEAKER
CENTER
: 8 MIN. /SPEAKER
REAR
: 8 MIN. /SPEAKER
SWITCHED
16
(Europe model)
MAINS
100W MAX. TOTAL
SWITCHED
To AC outlet
If you use
left position
Center
The impedance must be 6
speaker
or higher.
Rear
The impedance of each
speakers
speaker must be 6
higher.
If you use one pair of main
speakers, the impedance of
each speaker must be 4
higher.
Main
speakers
If you use two pairs of main
speakers, the impedance of
each speaker must be 8
higher.
After completing all connections, connect the AC power
cord to an AC power outlet. Disconnect the AC power cord
if you will not use this unit for a long period of time.
Europe model .................................................... 2 OUTLETS
U.K. model .......................................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC OUTLET(S)
is controlled by this unit's STANDBY/ON (or POWER).
These outlets will supply power to any connected
component whenever this unit is turned on. The maximum
power (total power consumption of components) that can be
connected to the AC OUTLET(S) is 100 W.
right position
The impedance must be 8
or higher.
The impedance of each
or
speaker must be 8
higher.
If you use one pair of main
speakers, the impedance of
or
each speaker must be 8
higher.
If you use two pairs of main
speakers, the impedance of
or
each speaker must be 16
higher.
or
or
or