DirectConnect 23878 Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Cremagliere e cavalletti DirectConnect 23878. DirectConnect 23878 4. Professional series racks bar rack

Stampa la pagina

Table of Contents

1.0 Hardware List.....................................

2.0 Features..............................................

3.0 Package Contents..............................

4.0 Installation Guide..............................

5.0 Operation and Adjustment..............

6.0 Optional Accessories........................

AFETY

These DirectConnect

Professional Series Racks are intended for

use only within the maximum weights indicated. See apparatus

instructions. Use with products heavier than the maximum

weights indicated may result in instability, causing possible injury.

Do not climb on, rock, shake, stand on, or tilt your Professional

Series Racks.

Only someone with good mechanical aptitude, who has

experience with basic building construction, and who fully

understands this manual, should install this product.

Safety gear and proper tools must be used. A minimum of two

people should be required for this installation. Failure to use

safety gear can result in property damage, serious injury or death.

This product contains small items that could be a choking hazard

if swallowed. Keep these items away from young children.

Never exceed the Maximum Load Capacity.

Due to the height and weights of the Professional Series Racks do

not move by yourself assistance is required. Always use an

assistant or mechanical lifting equipment to safely lift and

position equipment.

Tighten screws firmly, but do not over-tighten. Over-tightening

can damage the items, greatly reducing their holding power.

If you do not understand correct installation instructions,

MPORTANT:

please consult your regular installation specialist

ARNING

Installing & Adjusting the Front (1) & Back (2) Doors.

The Front Door (1) and the Back Door (2) are removable at any time. Just pull

down on the top tab while holding the door. The top of the door will then fall out

of place, then pull up on the bottom tab and lift the door out of the frame.

There may be times when the door may need to open in the other direction. The

door's opening direction can be changed. Remove the door and turn it so that the

handle is on the other side. Insert the tabs into the holes and close the door.

5.0 OPERATION AND ADJUSTMENT

The DirectConnect® Professional Series mounting rails 10-32 pre - threaded

holes. These mounting rails are labeled in EIA standard rack space increments

allowing for easy equipment alignment.

Select the location that the equipment is to be mounted and screw down the

equipment with 10-32 bolts (E). The mounting rails have pre-threaded 10-32

holes just screw equipment directly into desired position.

If the equipment has mounting with hooks, just hook the bracket into position for

any equipment that has mounting brackets with hooks.

The DirectConnect® Professional Series Racks are equipped with locking heavy

duty casters to easily move the rack. There are four (4) adjustable locking feet (A)

on the base of the rack, use a wrench to adjust the feet until the legs are lowered

enough that the wheels are slightly off the ground and lock with nut to base. Also

they ensure that the rack does not tip forward when a heavy drawer is pulled out.

(CAUTION - feet may damage flooring if rack is moved when loaded with equip-

ment)

Fixed Shelves / Sliding Shelves - secured to the mounting rails using supplied 10-

32 bolts (E) .

CAUTION: To avoid damage to your components due to overheating, ensure that there

is adequate space between each unit for proper airflow. It is important to maintain an

operating temperature inside of the rack that does not exceed 104°F (40°C).

IMPORTANT: Do not force the bolt into the hole, which may damage equipment and

injure a person. Do not use electric drill to fasten any bolts.

Fig. 6