Yamaha ATS-1010BL Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha ATS-1010BL. Yamaha ATS-1010BL 20. Front surround system

Stampa la pagina
Yamaha ATS-1010BL Manuale d'uso
Additional Information
3
Press the button below of the main unit to
select the operation you want the unit to
learn.
Operation you
want the unit to
learn
Volume down
VOLUME –
Volume up
VOLUME +
Power on/standby
mode
4
Point your TV remote control at the
remote control sensor and press the
respective button twice or three times
until the indicator changes from flashing
green to lit green.
Press
Indicator
(1 sec)
Flashes
rapidly
Release
(1 sec)
Flashes
Press
(1 sec)
Flashes
rapidly
Success in learning
Fault in learning
The UNIVOLUME, CLEAR VOICE and
SURROUND indicators flash in green
simultaneously for about 3 seconds.
5
Repeat steps 3 and 4 to make the unit
learn the other operations.
6
Press the
button of the main unit for
more than 3 seconds to finish the remote
control learning mode.
Release the
button of the main unit when all the
indicators light up in green. The unit enters standby
mode.
10
En
The button
The Indicator
of the unit
flashes in green
Approx.
30 cm
(1 ft)
e.g.
Volume up
Notes
• The unit will automatically set to standby mode if the unit
in the remote control learning mode is left turned on for 5
minutes without any operation being performed.
• If learning fails, try again with your TV turned off. Note
that screen glare may disturb TV remote control learning.
Removing all learned TV remote
control operations
1
Set the unit to standby mode.
2
Press both the INPUT
button and
button of the
main unit, release the
button first, then release the
INPUT button.
3
Press the INPUT button of the main unit
again for more than 3 seconds.
4
Release the INPUT button of the main unit
when qD DTS indicator flashes.
Press the
button of the main unit for more than 3
seconds to finish the remote control learning mode, or
to have the unit learn operations of another TV
remote control.

Resetting the unit

Should the unit freeze for any reason, this may be
remedied by initiating the factory settings.
1
Set the unit to standby mode.
2
Press and hold the
unit for more than 3 seconds.
All the indicator flashes in green.
3
Release the
button of the main unit.
Flashes in
red
button of the main