Yamaha DSP-E390 Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha DSP-E390. Yamaha DSP-E390 16. Natural sound digital sound field processor
Stampa la pagina
- 1. Table of Contents
- 2. Safety Instructions
- 3. Supplied Accessories
- 4. Profile of this Unit
- 5. Speaker Setup
- 6. Integrated Amplifier or Stereo Receiver
- 7. Connections
- 8. Connecting Speakers
- 9. Identification of Controls
- 10. Speaker Balance Adjustment
- 11. Using Digital Sound Field Processor (DSP)
- 12. Notes about the Remote Control Transmitter
- 13. Troubleshooting
- 14. Specifications
SPEAKER BALANCE ADJUSTMENT
This procedure lets you adjust the sound output level balance between the front, center, and rear speakers using the built-in test
tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from
each speaker. This is important for the best performance of the digital sound field processor.
2
1
Set to the "
2
Turn on the power of this unit and the amplifier etc.
3
Turn the DSP on, so that a DSP program name appears
on the display.
EFFECT
4
Select the
PRO LOGIC or
ENHANCED mode, so that the corresponding name is
illuminated on the display.
PROGRAM
10
5 3
1
6 4
∞
" position.
POWER
CONCERT
HALL
PRO LOGIC
PRO LOGIC
4
PRO LOGIC
—
SUR.
ROCK
6
TEST
CENTER MODE
DELAY
TIME
+
–
5
Select the center channel output mode according to
your speaker configuration.
(Refer to "SPEAKER CONFIGURATION" on page 5.)
CENTER
MODE
On the feature of each mode, refer to the "Notes" shown
below.
6
TEST
Notes
In step 5, when you select the center channel output mode,
note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE:
Select this mode when you use the center
speaker approximately same sized as the front
speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the
center speaker. The center sound will be
output from the left and right front speakers.
If you will select a DSP program on the remote control
transmitter, you can skip step 3. Pressing on a program
selector button will turn the DSP on and select the
corresponding program.
PROGRAM
ENHANCED
CNCT VIDEO
MONO MOVIE
HALL
3
ON/OFF
EFFECT
5
MASTER
VOLUME
+
–
NORMAL
WIDE
PHANTOM
NORMAL
WIDE
PHANTOM
ms
TEST
Flashes continuously.