Yamaha DXS15XLF-D Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha DXS15XLF-D. Yamaha DXS15XLF-D 31. Powered loudspeakers/subwoofer
Anche per Yamaha DXS15XLF-D: Manuale d'uso (31 pagine), Manuale d'uso (31 pagine), Manuale d'uso (31 pagine)
Stampa la pagina
Power section
!2
!2 [AC IN] jack
Connect the supplied AC power cord here. First, connect
the power cord to this product, then insert the power cord
plug into the AC outlet. When removing the power cord,
perform this procedure in reverse order.
WARNING
Use only the supplied power cord/plug.
CAUTION
Be sure to turn the power off before connecting or
disconnecting the power cord.
Insert the power cord fully until it is locked by the latching
lock mechanism (V-Lock).
Press the V-Lock latch to disconnect the power cord.
!3 Power switch
Turns the power supply on [–] or off [ ].
WARNING
A small amount of current flows even when the
power switch is off. If you will not use the speaker
for a long time, be sure to unplug the power cord
from the outlet.
NOTE
• Depending on the timing when the power switch is turned on/
off, it might take up to 15 seconds for the power to turn on.
• When using multiple devices, we recommend turning each
device on one at a time. If multiple devices are turned on at the
same time, the devices might not start up correctly due to a
voltage drop at the power supply.
Dante section (Dante models only)
!3
!4
!4 Dante jacks
These are etherCON jacks for a Dante network. Both jacks
are primary connections. They can be used for daisy
chain connections. For details, refer to the Reference
Manual.
Use STP (Shielded Twisted Pair) cables to prevent electromag-
netic interference. Make sure that the metal parts of the plugs are
electrically connected to the STP cable shield by conductive tape
or comparable means.
!5 [LINK] indicator
Shows the Dante communication status. Lights green
when an Ethernet cable is connected correctly to the
Dante jack.
!6 [1G] indicator
Lights orange when the Dante network is functioning as
Gigabit Ethernet.
!7 [SYNC] indicator
Lights steady or flashes green according to the Dante
communication status, as shown in the following table.
!5
!6
!5
NOTE
Operating normally as a word clock
Steady
slave
Operating normally as a word clock
Continuously flashing
master
Periodically flashing
Incorrect word clock setting
one time
Periodically flashing
Dante network cable not connected
two times
Periodically flashing
Incorrect Dante network connection
three times
Functions
!6
!4
!7
9