Yamaha Electone HS-5 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha Electone HS-5. Yamaha Electone HS-5 20. Serie hs monitor da studio alimentato e subwoofer alimentato
Anche per Yamaha Electone HS-5: Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (21 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale di servizio (43 pagine), (Italian) Manuale Di Istruzioni (20 pagine)

Stampa la pagina

Rear Panel

The HS8/HS7/HS5/HS8S switches and connectors are located on the rear panel, as described below.

HS8/HS7/HS5

HS8/HS7/HS5/HS8I/HS7I/HS5I/HS8S Owner's Manual

Speaker Input and Response Control

5 Power switch

Turns power to the speaker ON or OFF.

Rock the switch to the right [

the left [

panel will light when the power is ON.

NOTICE

• Turning the power switch ON and OFF in rapid succession can cause

the device's electronics to malfunction. Please wait for 3 seconds or

more after turning the power OFF before turning it ON again.

• Even when the power switch is turned off, electricity is still flowing to

the product at the minimum level. When you are not using the product

for a long time, make sure to unplug the power cord from the wall AC

outlet.

6 AC IN connector

Connect the supplied power cable here. First connect the

power cord to the speaker, then insert the power cord plug

into the AC outlet.

1 LEVEL control

Adjusts the output level of the speaker.

When set to the 12-o'clock position the speaker is

optimized for a nominal input level of +4 dB.

2 INPUT 1/2 connector

These connectors receive the input signal to the

speaker. Two input connectors are provided: one

balanced XLR connector, and one balanced (TRS)

phone jack.

NOTE The XLR and phone jack input connectors can not be

used simultaneously. Use only one input connector at a

time.

NOTE Refer to "Connectable cables" on page 5 for more

connector details.

3 ROOM CONTROL switch

Adjusts the speaker's low-frequency response.

This switch can be used to compensate for

exaggerated low-frequency response that can be

caused by reflections in some listening environments.

Setting the switch to the [0] position produces a flat

frequency response. The [-2 dB] setting attenuates

the range below 500 Hz by 2 dB, and the [-4 dB]

setting attenuates the range below 500 Hz by -4 dB.

4 HIGH TRIM switch

Adjusts the speaker's high-frequency response.

Setting the switch to the [0] position produces a flat

frequency response. The [+2 dB] setting boosts the

range above 2 kHz by 2 dB, while the [-2 dB] setting

attenuates the range above 2 kHz by -2 dB.

] to turn the power OFF. The logo on the front

] to turn the power ON, or to