Yamaha HS8I Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha HS8I. Yamaha HS8I 20. Powered studio monitor and powered subwoofer
Anche per Yamaha HS8I: Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine)
Stampa la pagina
Rear Panel
The HS8/HS7/HS5/HS8S switches and connectors are located on the rear panel, as described below.
HS8/HS7/HS5
6
HS8/HS7/HS5/HS8I/HS7I/HS5I/HS8S Owner's Manual
Speaker Input and Response Control
1
2
3
4
5
6
5 Power switch
Turns power to the speaker ON or OFF.
Rock the switch to the right [
the left [
panel will light when the power is ON.
NOTICE
• Turning the power switch ON and OFF in rapid succession can cause
the device's electronics to malfunction. Please wait for 3 seconds or
more after turning the power OFF before turning it ON again.
• Even when the power switch is turned off, electricity is still flowing to
the product at the minimum level. When you are not using the product
for a long time, make sure to unplug the power cord from the wall AC
outlet.
6 AC IN connector
Connect the supplied power cable here. First connect the
power cord to the speaker, then insert the power cord plug
into the AC outlet.
1 LEVEL control
Adjusts the output level of the speaker.
When set to the 12-o'clock position the speaker is
optimized for a nominal input level of +4 dB.
2 INPUT 1/2 connector
These connectors receive the input signal to the
speaker. Two input connectors are provided: one
balanced XLR connector, and one balanced (TRS)
phone jack.
NOTE The XLR and phone jack input connectors can not be
used simultaneously. Use only one input connector at a
time.
NOTE Refer to "Connectable cables" on page 5 for more
connector details.
3 ROOM CONTROL switch
Adjusts the speaker's low-frequency response.
This switch can be used to compensate for
exaggerated low-frequency response that can be
caused by reflections in some listening environments.
Setting the switch to the [0] position produces a flat
frequency response. The [-2 dB] setting attenuates
the range below 500 Hz by 2 dB, and the [-4 dB]
setting attenuates the range below 500 Hz by -4 dB.
4 HIGH TRIM switch
Adjusts the speaker's high-frequency response.
Setting the switch to the [0] position produces a flat
frequency response. The [+2 dB] setting boosts the
range above 2 kHz by 2 dB, while the [-2 dB] setting
attenuates the range above 2 kHz by -2 dB.
] to turn the power OFF. The logo on the front
] to turn the power ON, or to